Scribd
Upload
11 views8 pages

Tutorial 7 25022025

This document is a tutorial for Analog Electronics focusing on various oscillator circuits, including Wien Bridge, phase shift, Hartley, and Colpitts oscillators. It contains problems related to calculating component values for specific frequencies, determining frequency ranges, and analyzing circuit characteristics. The tutorial is intended for students at BITS Pilani, K K Birla Goa Campus, and includes practical design and analysis tasks.

Uploaded by

f20221216
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views8 pages

Tutorial 7 25022025

This document is a tutorial for Analog Electronics focusing on various oscillator circuits, including Wien Bridge, phase shift, Hartley, and Colpitts oscillators. It contains problems related to calculating component values for specific frequencies, determining frequency ranges, and analyzing circuit characteristics. The tutorial is intended for students at BITS Pilani, K K Birla Goa Campus, and includes practical design and analysis tasks.

Uploaded by

f20221216
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

Analog Electronics

Tutorial -7
25-02-2025

BITS Pilani, K K Birla Goa Campus


Q1. A Wien Bridge Oscillator circuit is required to generate a sinusoidal
waveform of 5,200 Hertz (5.2kHz). Calculate the values of the frequency
determining resistors R1 and R2 and the two capacitors C1 and C2 to
produce the required frequency.
Q2. Determine the maximum and minimum frequency of oscillations of a
Wien Bridge Oscillator circuit having a resistor of 10kΩ and a variable
capacitor of 1nF to 1000nF.
Q3. Design a phase shift oscillator circuit to get output frequency of
6.5 kHz. The capacitor value should be used in the oscillator circuit is
1 nF.
Q4. A Hartley Oscillator circuit having two individual inductors of 0.5mH each,
are designed to resonate in parallel with a variable capacitor that can be
adjusted between 100pF and 500pF. Determine the upper and lower
frequencies of oscillation and also the Hartley oscillators bandwidth.
Q5. A Colpitts Oscillator circuit having two capacitors of 24nF and 240nF
respectively are connected in parallel with an inductor of 10mH.
Determine the frequency of oscillations of the circuit, the feedback
fraction and draw the circuit.
Q6. (a) For the circuit in Fig., sketch and label the transfer characteristic
Vo-Vi. The diodes are assumed to have a constant 0.7 V drop when
conducting, and the op amp saturates at ± 12 V. What is the maximum
diode current?
(b) Consider the same circuit with R1 eliminated and R2 short-circuited.
Sketch and label the transfer characteristic Vo-Vi. Assume that the
diodes have a constant 0.7-V drop when conducting and that the op amp
saturates at ± 12 V.
Q7. For the given circuit, find the range of frequency at the output.

You might also like