Scribd
Upload
4 views4 pages

EX-3 NETWORK Rohit

The document outlines an experiment on IPv6 Addressing Scheme for a Network System Administration course. It details the aim of configuring, verifying, and troubleshooting IPv6 addresses in a LAN/WAN environment using Cisco Packet Tracer. The document also lists common troubleshooting issues and commands for fault isolation, along with the learning outcomes from the practical exercise.

Uploaded by

rohit2616gupta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views4 pages

EX-3 NETWORK Rohit

The document outlines an experiment on IPv6 Addressing Scheme for a Network System Administration course. It details the aim of configuring, verifying, and troubleshooting IPv6 addresses in a LAN/WAN environment using Cisco Packet Tracer. The document also lists common troubleshooting issues and commands for fault isolation, along with the learning outcomes from the practical exercise.

Uploaded by

rohit2616gupta
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Student Name: Rohit Kumar Gupta UID: 23MCA20401

Branch: MCA Section/Group: 7 'B'

Semester: 4th Date of Performance:16-02-2025

Subject Name: Network System Administration

Subject Code: 23CAH-753

EXPERIMENT- 03
Aim/Overview of the practical: IPv6 Addressing Scheme: Addressing
requirements in a LAN/WAN environment. Configure, verify, and troubleshoot.

Apparatus: Software requirements


• Cisco Packet Tracer

Task to be done: Configuration, verification and troubleshooting.


Steps to CreateCreate a new file in Cisco Packet Tracer and drag and drop Router,
Switches and PCs in the workspace.

Connect all the devices with appropriate cables.


Step 2- Assign IP addresses of different subnets to the PCs

Do the same for all the other pc’s just keeps the gateway address same for both sides
Step 3- Set router for the networks to communicate in CLI
Step 4- Send Message from PC to PC and check its status

Learning outcomes (What I have learnt):

Troubleshooting
1. Common Issues:
• Missing IPv6 unicast-routing: Ensure ipv6 unicast-routing is enabled on
routers.
• Incorrect Prefix Length: Verify /64 subnet mask is used.
• Misconfigured Default Gateway: Ensure PCs have the correct gateway
address.
• Cable or Port Issues: Check connections and interface statuses with show
ipv6 interface brief.

2. Commands to Isolate Faults:


• debug ipv6 icmp = Check ICMPv6 packet flow
• show ipv6 neighbors = Verify neighbor discovery protocol
• show ipv6 ospf neighbor = If OSPFv3 is used

Learning Outcomes:
• Practical Knowledge of Network Design.
• Understanding Network Configurations.

Teacher Signature

You might also like