Scribd
Upload
108 views4 pages

Firmware Upgrade Instruction

Uploaded by

Jennifer Bugueño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
108 views4 pages

Firmware Upgrade Instruction

Uploaded by

Jennifer Bugueño
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

F/W Upgrade Guide

Samsung Electronics
Step1. How to prepare the USB Memory Drive
1. Download the firmware file from Samsung.com into your computer.
File Name : Firmware_USB.zip

2. Connect the USB Memory Drive to the USB port of your PC.
Copy the file to USB Memory Drive.

3. Follow below steps to extract the file and make a folder for firmware.
The folder should have same name with the file and exist in the root directly
※ An extracting process might be different by application in PC
3-A. Click the file and ‘Extract All…’. Then select USB driver that files will be extracted.

Firmware_USB.zip

3-B. Make sure that USB Driver has a two folders named
‘SAT-iMX8M24WWC’ and ‘SAT-MT8532D24WWC’.

ex)
OK NG
Firmware_USB
SAT-iMX8M24WWC
SAT-iMX8M24WWC

SAT-MT8532D24WWC
SAT-MT8532D24WWC

4. Safely disconnect the USB memory drive by clicking in ‘Safely Remove’


in Task Bar.
Step2. How to upgrade the Firmware by USB
(For HW-Q9**D/Q8**D/Q7**D)

1. Turn on the Soundbar and insert the USB drive into the SERVICE
port located on the bottom of the Main Unit. The software will begin to
update automatically in less than one minute.

2. A sequence of “UPDATE” → “BYE” → “ON” will appear on the display 3 times.


It would take around 6 minutes

3. After the 3 cycles are complete, the Soundbar will restart and last source
used will appear on the display for about 20 seconds and then it will go off

(“UPDATE → BYE → ON“) 3 times → “D.IN” → OFF

※ Cycle and duration of update may differ by models

※ Important
. Please DO NOT turn off the power or remove the USB while the update.
Step2. How to upgrade the Firmware by USB
(For HW-S8**D/S7**D/S6*D)

1. Turn on the Soundbar and insert the USB drive into the SERVICE
port located on the bottom of the Main Unit. The software will begin to
update automatically in less than one minute.

2. The update sequence as below table.(It would take around 6 minutes)

3. After update, product will power off automatically.


※ When there are more than one function blocks to be updated(B/E,Micom,etc),
the updates for each function blocks will be executed sequentially after reboot
so it may reboot multiple times.

※ Important
. Please DO NOT turn off the power or remove the USB while the update.

You might also like