Scribd
Upload
9 views1 page

CSCX92x Replacing Photoconductor Unit

The document provides instructions for replacing the photoconductor in specific printer models while emphasizing precautions against static electricity and light exposure. It details the steps to remove the old unit, unpack the new one, and clean the printhead lens before installation. Additionally, it includes a warning about not touching the photoconductor drum to maintain print quality.

Uploaded by

Amdea
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views1 page

CSCX92x Replacing Photoconductor Unit

The document provides instructions for replacing the photoconductor in specific printer models while emphasizing precautions against static electricity and light exposure. It details the steps to remove the old unit, unpack the new one, and clean the printhead lens before installation. Additionally, it includes a warning about not touching the photoconductor drum to maintain print quality.

Uploaded by

Amdea
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

REPLACING THE PHOTOCONDUCTOR

CS921, CS923, CS927, CX920, CX921,


CX922, CX923, CX924, and CX927

Warning—Potential Damage: Some parts of the printer are easily


damaged by static electricity. Before touching any parts or components in
an area marked with the static-sensitive symbol, touch a metal surface in an
area away from the symbol.

Remove the photoconductor unit. Unpack the new photoconductor unit.

Warning—Potential Damage: Do not expose the photoconductor unit to


direct light for more than one minute. Extended exposure to light may cause
print quality problems.

Warning—Potential Damage: Do not touch the photoconductor drum.


Doing so may affect the quality of future print jobs.
Open door A. Remove the waste toner
bottle.

Insert the new photoconductor unit.

Using the printhead wiper, clean the Insert the waste toner bottle, and then SCAN TO WATCH
printhead lens. close the door. THE VIDEO

You might also like