Scribd
Upload
8 views

Assignment 1

The document outlines an assignment consisting of various tasks related to electrical engineering concepts, including definitions of key terms such as accuracy and absolute error. It includes calculations for limiting error, derivations of bridge equations, and problems involving impedance and frequency in circuits. Additionally, it requires the determination of equivalent circuits and the frequency of a Wien's Bridge circuit.

Uploaded by

Suvojit Ghosh
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
8 views

Assignment 1

The document outlines an assignment consisting of various tasks related to electrical engineering concepts, including definitions of key terms such as accuracy and absolute error. It includes calculations for limiting error, derivations of bridge equations, and problems involving impedance and frequency in circuits. Additionally, it requires the determination of equivalent circuits and the frequency of a Wien's Bridge circuit.

Uploaded by

Suvojit Ghosh
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ASSIGNMENT -1

1. Define the following terms (2x4)=8


a. Accuracy
b. Precession
c. Absolute error
d. True value
2. A 0- 150 v voltage has guaranteed accuracy 1% of the full scale reading.
The voltage measured by this instrument is 50 Volt. Calculate the Limiting
Error. (3)
3. Derive the equation with proper diagram of the following bridges –
a. Maxwell Bridge (4X5)=20
b. Hay’s Bridge
c. Wien Bridge
d. Capacitance comparison Bridge
4. A capacitance comparison bridge ( similar angle bridge ) used to measure
a capacitive impedance at a frequency of 2KHz. Bridge constants at
balance are – (5)
C3 = 100 µF
R1 = 10 KΩ
R2 = 50 KΩ
R3 = 100 KΩ
Find the equivalent series circuit of unknown impedance.
5. The arm of an AC constant bridge are arranged as follows-
AB & BC are non-reactive resistance of 100Ω each.
AD is a standard variable reactor L1 of resistance 32.7Ω
CD consists of standard variable resistor R in series with a coil of
unknown impedance Z, balance was found with L1 =50mH & Z=1.36 R.
Find the R & L of the coil. (5)
6. Find the series equivalent impedance & resistance of the network that
causes an opposite angle of null with following bridge arm. (5)
Ѡ=3000rad/sec, R2 = 10KΩ, R1 = 2KΩ, R3 = 1KΩ, C1 = 1µF
7. A Wien’s Bridge circuit consists of the following – (5)

R1 = 4.7KΩ
R2 = 20KΩ
R3 = 10KΩ
R4 =100 KΩ
C1 = 5nF
C3 = 10nF
Determine the frequency of the circuit.

You might also like