Scribd
Upload
7 views

Assignment -02

This document outlines Assignment #02 for the EE231 Electronic Devices and Circuits course at Ghulam Ishaq Khan Institute, due on February 20, 2025. The assignment consists of various problems related to diode characteristics, network analysis, and rectifier sketches, totaling 30 marks. Students are warned against plagiarism, as it will result in negative marking.

Uploaded by

Mir Hadi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
7 views

Assignment -02

This document outlines Assignment #02 for the EE231 Electronic Devices and Circuits course at Ghulam Ishaq Khan Institute, due on February 20, 2025. The assignment consists of various problems related to diode characteristics, network analysis, and rectifier sketches, totaling 30 marks. Students are warned against plagiarism, as it will result in negative marking.

Uploaded by

Mir Hadi
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Faculty of Electrical Engineering Ghulam Ishaq Khan Institute of

Engineering Sciences and Technology

EE231 Electronic Devices and Circuits (Fall 2025)


Assignment #02 Total Marks: 30

Due Date: Thursday, Feb 20, 2025

The assignment must be submitted by due date during lecture timings in class. Submissions after class timings will lead to
zero marks. Do not copy or you will get negative marking for your assignment.

Note: The following assignment will be evaluated against CLO-2.

1. a. Using the approximate characteristics for the Si diode, identify VD , ID , and VR for the
following circuit. [2]
b. Perform the same analysis as part (a) using the ideal model for the diode. [2]
c. Do the results obtained in parts (a) and (b) suggest that the ideal model can provide a good
approximation for the actual response under some conditions? [1]

2. Analyze the following network and determine Vo 1, Vo 2 and I for following network? [5]

3. Assuming an ideal diode, sketch Vi , Vd , and Id for the half-wave rectifier of following fig. The
input is a sinusoidal waveform with a frequency of 60 Hz. Determine the value of Vi from the
given dc level. [5]
4. Sketch vo for the network and discover the dc voltage available. [5]

5. Distinguish v o for each network of with the input shown. [5]

6. For the following network, determine the range of Vi that will maintain VL at 8 V and not exceed
the maximum power rating of the Zener diode. [5]

You might also like