MSM5105™ MOBILE STATION MODEM

TM
QUALCOMM CDMA TECHNOLOGIES H T T P : / / W W W. C D M AT E C H . C O M ENABLING THE FUTURE OF COMMUNICATIONS
MSM5105 ™ MOBILE STATION MODEM

MSM5105
Antenna
Mobile Station Modem
USB PC
19.2/19.68/19.8 MHz PLL Connectivity
UART 1
Test/Debug
VCTXO UART 2 System

HK ADCs Charging
Duplexer PM1000 System
Voltage Regulator

Microprocessor Bus Peripheral

ARM7TDMI Address/Data Circuits

RF Controls
RF
RFR3100 General-Purpose Interface Bus
Interface
R-UIM Controller R-UIM

Power 1 2 3
Amplifier 4 5 6
Keypad
General- 7 8 9
Purpose * 0 #
IFR3000 CDMA
RINGER
Processor Interface

Vocoder
EVRC
13k
Tx
DACs
RFT3100
DFM
CODEC
Processor

SBI MODE Select External Mode Selection

Interface

JTAG Interface Digital Test Bus

MSM5105 Functional Block Diagram

Overview efficiencies and the rapid time-to-market that the solution delivers for
QUALCOMM’s 3G CDMA CDMA2000® 1X solution, the MSM5105™ next-generation services.
Mobile Station Modem™ (MSM™) chipset and software is designed
to the IS-2000 Standard and enables a doubling of overall IS-95A/B QUALCOMM has developed a seamless migration path that will allow
voice capacity and new, higher-data-rate services. With initial data operators to move easily into the next-generation of wireless
rates that exceed the ITU requirement for full wide area mobility, the communications. This path provides compatibility among IS-95A, IS-95B
MSM5105 solution will support 153 kilobits per second (kbps), and 3G CDMA2000 1X networks. Manufacturers will benefit by
providing manufacturers worldwide with the ability to develop developing products for these networks since they offer shorter product
consumer products that provide voice and high-speed data over development time, and reduced development and equipment costs by
wireless networks. Network operators will also benefit from the cost allowing the reuse of hardware, software and network protocols.
 QUALCOMM CDMA TECHNOLOGIES H T T P : / / W W W. C D M AT E C H . C O M ENABLING THE FUTURE OF COMMUNICATIONS TM
MSM5105 ™ MOBILE STATION MODEM

3G CDMA Enabling Chipset MSM5105 Features

QUALCOMM has developed the MSM5105 General Features
chipset and system software to support the Phase • Pin compatible with the MSM3100 in a 208 FBGA package
1 of the IS-2000 Standard (CDMA2000 1X). To • Embedded QDSP2000™ digital signal processor core, enabling a
enable rapid design times and an easy migration comprehensive set of features such as voice recognition, voice memo,
path to CDMA2000 1X, the MSM5105 chipset speech compression, acoustic echo cancellation, noise suppression
builds on the highly successful IS-95A/B and audio enhancement
architecture of the MSM3100™ solution. The MSM5105 chipset • Integrated USB device controller for fast and simple PC interconnect
includes QUALCOMM’s existing RFR3100™, IFR3000™, • EVRC, 13K QCELP® Vocoder support
RFT3100™, and PM1000™ devices. These devices perform all of • High-speed data using both fundamental and supplemental channels
the signal processing and power management in the subscriber unit, • Supports peak rates of up to 153 kbps
from IF to PCM, for compliance with the proposed 3G CDMA2000 • Voice Recognition
1X Revision 0 standard. – Speaker-dependent, Speaker-independent and Voice prompt
support
The MSM5105 device is a digital baseband chip that enables – Multiple language support
manufacturers to meet or exceed the specifications of mobile • CMX™ support for MIDI, text and graphics-based multimedia
stations for worldwide cdmaOne™ and CDMA2000 1X systems, applications with optional software
including IS-95A, IS-95B, IS-2000 and its variants for PCS in Japan, • Enhanced Tx AGC control, eliminating the need for external gain-step
Korea and South America. Featuring support for Quick Paging compensation circuitry
Channel and including an improved searcher, the MSM5105 • 16-bit wide Flash and SRAM support
provides an increase in handset standby time of up to 50-percent • Backward compatible with cdmaOne standards
over IS-95A/B handsets. Pin compatible with the MSM3100 device, • Standard MIDI ringer
the MSM5105 device will be available in the same 208-pin Fine • R-UIM interface
Pitch Ball Grid Array (FBGA) production package.
CDMA2000 1X RTT Features Supported by MSM5105 Device
The MSM5105 device integrates functions that support a tri-mode • Fast 800 Hz Forward Power Control
CDMA/FM subscriber unit. Subsystems within the MSM5105 device • Quasi-Orthogonal Functions
include a CDMA processor, a Digital FM (DFM) processor, a • Supplemental Channel (SCH) support
QUALCOMM-designed DSP for voice compression, an ARM® • IS-2000 Forward Quick Paging Channel (F-QPCH) support
ARM7TDMI® microprocessor. Also integrated in the MSM5105 • Convolutional codes on SCH
device are analog functions such as an audio voice codec, PLL, • ITU 144 kbps requirement achieved
transmit DACs, ADCs, memories, a Universal Serial Bus (USB) – Forward dedicated control channel (F-DCCH)
device controller, a R-UIM controller, 48 user-defined, – Reverse dedicated control channel (R-DCCH)
general-purpose pins, peripheral interfaces, and an enhanced clock • Radio Link Protocol (RLP3)
and power management architecture. • Quick Paging Channel

Copyright © 2004 QUALCOMM Incorporated. All rights reserved. QUALCOMM and

QCELP are registered trademarks, and MSM5105, Mobile Station Modem, MSM,
MSM3100, RFR3100, IFR3100, IFR3000, RFT3100, PM1000, QDSP2000 and CMX
are trademarks of QUALCOMM Incorporated. CDMA2000 is a registered trademark of
the Telecommunications Industry Association (TIA USA). cdmaOne is a trademark of
the CDMA Development Group (CDG). ARM7TDMI, ARM and the ARM logo are
trademarks or registered trademarks of ARM Limited. All other trademarks and service
marks are the property of their respective owners. Data subject to change without
notice.
Printed in USA 4/2004 MSM5105-SS X11