Ratio Test
Ratio Test
Before proceeding with the test let’s do a quick reminder of factorials. This test will be particularly
useful for series that contain factorials (and we will see some in the applications) so let’s make sure
we can deal with them before we run into them in an example.
0! = 1 by definition
1! = 1
2! = 2 (1) = 2
3! = 3 (2) (1) = 6
In the last computation above, notice that we could rewrite the factorial in a couple of different ways.
For instance,
= n (n − 1) (n − 2) ⋯ (n − k) ⋅ (n − (k + 1))!
= n (n − 1) (n − 2) ⋯ (n − k) ⋅ (n − k − 1)!
Also, when dealing with factorials we need to be very careful with parenthesis. For instance,
(2n)! ≠ 2 n! as we can see if we write each of the following factorials out.
(2n)! = (2n) (2n − 1) (2n − 2) ⋯ (3) (2) (1)
Again, we will run across factorials with parenthesis so don’t drop them. This is often one of the more
common mistakes that students make when they first run across factorials.
Ratio Test
∣ an+1 ∣
L = lim ∣ ∣
n→∞∣ an ∣
Then,
Notice that in the case of L = 1 the ratio test is pretty much worthless and we would need to resort
to a different test to determine the convergence of the series.
Also, the absolute value bars in the definition of L are absolutely required. If they are not there it will
be impossible for us to get the correct answer.
∞ n
(−10)
∑
2n+1
4 (n + 1)
n=1
Show Solution
As seen in the previous example there is usually a lot of canceling that will happen in these. Make
sure that you do this canceling. If you don’t do this kind of canceling it can make the limit fairly
difficult.
Show Solution
∞ 2
n
∑
(2n − 1)!
n=2
Show Solution
∞ n
9
∑
n+1
n=1
(−2) n
Show Solution
In the previous example the absolute value bars were required to get the correct answer. If we hadn’t
9
used them we would have gotten L = −
2
< 1 which would have implied a convergent series!
Now, let’s take a look at a couple of examples to see what happens when we getL = 1 . Recall that
the ratio test will not tell us anything about the convergence of these series. In both of these
examples we will first verify that we get L = 1 and then use other tests to determine the
convergence.
∞ n
(−1)
∑
2
n + 1
n=0
Show Solution
∞
n + 2
∑
2n + 7
n=0
Show Solution
So, as we saw in the previous two examples if we get L = 1 from the ratio test the series can be
either convergent or divergent.
There is one more thing that we should note about the ratio test before we move onto the next
section. The last series was a polynomial divided by a polynomial and we saw that we got L = 1
from the ratio test. This will always happen with rational expressions involving only polynomials or
polynomials under radicals. So, in the future it isn’t even worth it to try the ratio test on these kinds of
problems since we now know that we will get L = 1 .
Also, in the second to last example we saw an example of an alternating series in which the positive
term was a rational expression involving polynomials and again we will always get L = 1 in these
cases.
Let’s close the section out with a proof of the Ratio Test.
First note that we can assume without loss of generality that the series will start at n = 1 as we’ve
done for all our series test proofs.
Let’s start off the proof here by assuming that L < 1 and we’ll need to show that ∑ an is absolutely
convergent. To do this let’s first note that because L < 1 there is some number r such that
L < r < 1 .
∣ an+1 ∣
L = lim ∣ ∣
n→∞∣ an ∣
and because we also have chosen r such that L < r there is some N such that if n ≥ N we will
have,
∣ an+1 ∣
∣ ∣ < r ⇒ |an+1 | < r |an |
∣ a ∣
n
2
|aN +2 | < r |aN +1 | < r |aN |
3
|aN +3 | < r |aN +2 | < r |aN |
⋮
k
|aN +k | < r |aN +k−1 | < r |aN |
k
∑ |aN | r
k=0
This is a geometric series and because 0 < r < 1 we in fact know that it is a convergent series.
Also because |aN +k | < r
k
|aN | by the Comparison test the series
∞ ∞
∑ |an | = ∑ |aN +k |
n=N +1 k=1
∞ N ∞
we know that ∑ |an | is also convergent since the first term on the right is a finite sum of finite terms
n=1
∞
Next, we need to assume that L > 1 and we’ll need to show that ∑ an is divergent. Recalling that,
∣ an+1 ∣
L = lim ∣ ∣
n→∞∣ an ∣
and because L > 1 we know that there must be some N such that if n ≥ N we will have,
∣ an+1 ∣
∣ ∣ > 1 ⇒ |an+1 | > |an |
∣ a ∣
n
lim |an | ≠ 0
n→∞
because the terms are getting larger and guaranteed to not be negative. This in turn means that,
lim an ≠ 0
n→∞
Finally, we need to assume that L = 1 and show that we could get a series that has any of the three
possibilities. To do this we just need a series for each case. We’ll leave the details of checking to you
but all three of the following series have L = 1 and each one exhibits one of the possibilities.
∞
1
∑ absolutely convergent
2
n
n=1
∞ n
(−1)
∑ conditionally convergent
n
n=1
∞
1
∑ divergent
n
n=1
© 2003 - 2025 Paul Dawkins Page Last Modified : 8/13/2024