Dhaka Board-2022 a. What is called density?

b. Why does the air bubble rising from the bottom

The area of cross section of an object is 300 cm2, of the reservoir get bigger?
height 0.1 m and the mass of the object is 5.5 kg. c. Determine the water pressure at the bottom of the
a. What is pressure? cylinder.
b. Why there is no unit of strain? d. Whether the weight of the liquid removed by the
c. Determine the weight of the stimulate object in PQRS object will be equal to the weight lost by the
water. object, explain it mathematically. 4
d. For what change of volume of stimulate object, it
will float with fully immersed in water? Give Comilla Board-2022
mathematical logic.

Mymensingh
2

Look at the figure and answer the questions:

a. What Is strain? a. What is strain?
b. why does the density of matter decrease when b. Explain for flying fanus it is essential to change
temperature increases? density of air. 2
c. Determine the value of force c. How much upward force create in the bigger
d. Final pressure of mercury is felt at different piston?
depths of the three liquids of the stem— Analyze d. Whether it is possible to displace upward 3 cm in
mathematically. case of bigger piston- Explain mathematically.
Chattogram Board-2022

Rajshahi Board 2022

A wooden piece having 40 cm length, 20 cm
breadth and 10 cm height floated in the river water
and went to sea. The wooden piece was half
submerged in the river water. The massof the wood
is 4kg and density of sea water is 1.03x10-3kgm-3. a. What is stress? 1
a. Write down Pascal’s law. b. Which one is more painful to walk bare
b, Why cooking in presuure cooker is quick? footed on plain
c. Determine the maximum pressure of wooden bricks soling road or a brick chucked road?
piece on a floor, Explain. 2
d. What percentage of the wooden piece would Calculate the applied pressure by the body 'A'
float in sea water? Analyze mathematically. on surface ab. 3 d. Is the gold bar made by pure
Dinajpur Board 2022 gold or not? Mathematically
analyze
Sylhet Board 2022
 . Why does a boat float higher after its passengers
get down?Explain. 2
t c Determine the displacement of the big piston
in the stem. 3
d. If 5N, 12N and 30N force is applied to the small
piston respectively, what will be the force aquired
in the big
piston? Explain graphically.
Jashore Board 2020
A solid cylinder whose radius 5 cm and height 12
What Is stress? I I cm is dropped in the well which is fulfilled with
C. 110W much upward force will act on C2 piston, water. The mass of the cylinder is 240g and density
if 10 kg of water is 1000kgm-3.
b. What Is meant by Torricolli's vacuum? 2
What is called Elasticity? 1
mass kept on C1 piston? 3
. How will be the graph of (F1 Vs F2) if IN, 2N and Why does lightening in the sky? Explain it. 2
3N Determine the pressure at the bottom of the well.
threes we applied on C1 piston? Show it, 3
Will the cylinder float or sink in the water of well?
Jashore Board-2022
Explain it. 4

Sylhet board 2020 Scenario-1: The densities of two

liquid substances A and B are 1000 kgrn -3 and
20000 N force require to produce oil from an 0il 13600 kgm-3 respectively. Atmospheric pressure is
bean. Ratio of the radius of the smaller and greater
1.01 x 105Pa and g = 9.8ms-2
piston of a hydraulic press is I : 10. 100 N force
applied on the small piston and the outcome of this .
force displacement of the small piston is 30 cm and Scenario-2: The length of a rod at temperature 0°C
greater piston is 3 cm. is 2m. The coefficient of surface expansion of the
What is strain? substance of the rod is 22x10-6K-1.
a. Why it is possible to immersed of body in the
What is called solidification?
river when
this body floating in the ocean? Explain. 2 On which factors does heat capacity of an object
b. Determine the equal work done is happen in depend?
greater and Determine the final length of the rod if temperature
smaller piston in the mentioned stem. 3 of the rod is raised to 50°C in scenario-2. 3
c. How much time increase the radius of the
Which one is suitable between A and B to construct
greater piston for produce the necessary force
which is requir to oil production? Analyze a barometer in scenario-1? Express your opinion
mathematically through analysis. 4

Barishal Board-2022 Chittagong board 2020

4.

a. State the Pascal's law. 1

. Write down Hooke's Law. I b. Why the unit of stress and young's modulus are
same? Explain,
Calculate the increase in length of the bar? the brick and put them into the water. Analyze
d. Whether the works of the two pistons are same or mathematically. 4
not? Explain in view of Fig-2. 4
Dinajpur board 2020
In a hydraulic press the ration of diameters
of larger an( smaller piston is 5:1. If the
smaller piston travels some distance, the
larger piston gains a force of 300N.
What is buoyancy?
Why it is easy to make a hole with a sharp pin in a
paper.
Find the applied force on the smaller piston.
According to the stem, the works done are same of
the two pistons — Analyze with the help of
"Principle of multiplication of force."
mymansing board 2020
3.

In figure the radii of the cylinders C 1 and C2 are

3cm and 6 cm respectively. If 1000 N force is
applied on the piston of C1, it is moved from M to
N at distance 6 cm. As a result the piston of C 2 is
moved 1 cm from position S to T.
a. What is called pressure?
b. Explain why the unit of stress is same as the unit
of modulus of elasticity.
c. Find out the experienced force on the piston of
cylinder C2. 3
d. Energy is not increased in the event of the above
stem. Express your opinion through analysis.
Dhaka Board 2020
The length, width and height of a brick is
25cm, 12cm and 6cm respectively. Mass of
the brick is 2.25kg. Density of water is
1000kgrn3. [g = 9.8ms2]
Write down Hook's law.
Why the density of the water below and upper
portion of the pond is different during hot sun?
2
Determine how much the maximum pressure acts
on the surface by the brick. 3
Whether it is sink or float when a pieces of same
size wood of density 400 kgrn-3 placed in pair with