SECTION 2 | Update/Change Parameter and Horsepower SECTION 3 | BLANK MODULE FLASHING [cont.

] SECTION 5 | RECOVERY
Note: Case file must be completed before this step. Note: In the event of programming failure:

1 Select the Parameter Upgrade

7 After Process Request is complete and
1 Select Recover.
tab and follow highlighted screen Status shows Downloaded. Return to
prompts for key cycles. Campaigns Tab to complete update.

2 8 2 Select associated VIN.

Enter Associated Case File Number. Select Flash Blank Module follow
highlighted Screen Prompts for key cycles.

3 Select Save Request and follow 9

highlighted screen prompts for key cycles. Select VIN.
Note: See Process Request. 3 Follow screen prompts for Key Cycles. NavKal
screen prompts will become highlighted.

4 Return to Campaigns tab to complete update.

Follow highlighted Screen Prompts 10
RED Cycle Key OFF
YELLOW Cycle Key ON
for key cycles.

SECTION 3 | BLANK MODULE FLASHING SECTION 4 | PROCESS REQUEST SECTION 6 | PROGRAMMING VERIFICATION CODE (PVC)
Note: Case file must be completed before this step. Note: Request type and status are displayed for each VIN. Note: After programming is complete under Process Requests Tab, status will show Pending PVC.

1 Select Blank Module Flashing tab

1 Select Process Requests tab and follow
highlighted screen prompts for key cycles.
Select Process Requests to complete
all pending requests.
2 1 Select Process Requests
and follow highlighted screen prompts to send history and create
for key cycles. a Programming Verification
2 Input Associated Case file and vehicle
Code (PVC). A PVC will
be generated against the
information; all fields must be populated. associated (VIN) number.

3 Select Save Request and follow

highlighted screen prompts for key cycles.
2 Select View PVC to
view or print PVC.
4 Select
5 Select module
Engine Platform. being replaced.

6 Follow highlighted Screen Prompts for key cycles.

Note: See Section 4 to Process Request.
SECTION 1 | Connecting to a Vehicle and Updating Calibration Version NavKal OVERVIEW

1 If calibration update is available, Existing and

New Calibration will be displayed.

2
QUICK REFERENCE GUIDE
Battery voltage must be above range to
begin programming, NavKal will display
Before using NavKal for the first Powered by:
highlighted voltage:
time, you are required to Enter
Select Update Dealer Information
Dealer Information.
RED 9.0 – 10.4 Volts under File on the Menu bar. Enter Dealer
YELLOW 10.5 – 12.4 Volts information and click Save.
GREEN 12.5 Volts or Higher
1 2
Install the Midtronics SMART Charger before
programming. See SFN 07-11 for details. 3

NavKal is an Electronic Control Module (ECM) programming

software that replaces all previous PC based ECM programming
Before connecting to a vehicle, select Diagnostic Interface under Tools. software (Nets, AutoUpgrade).

Software Features:
To begin updating, Select Update Calibration and • Offline calibration updating
follow highlighted screen prompts for key cycles. • Parameter and horsepower changes
3 • Program a blank module
System Requirements: • On-screen display of vehicle information, Including
• Supported EZ-Tech (Win XP or later) ECM software version and upgrade availability
• RP1210B diagnostic interface cable and latest supported drivers
• Read and clear engine DTCs
© 2014 Navistar, Inc. All rights reserved. All marks are trademarks of their respective owners. ?????????? • Create Programming Verification Code (PVC)