Scribd
Upload
6 views2 pages

Ec 206 Control Systems

The document outlines the Mid-Semester UG Examinations for Control Systems at the National Institute of Technology Silchar, scheduled for March 2022. It includes a series of compulsory questions covering topics such as differential equations for mechanical systems, block diagrams, signal flow graphs, and RLC circuit analysis. The exam consists of various questions with specified marks totaling 30.

Uploaded by

bisalbiki7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views2 pages

Ec 206 Control Systems

The document outlines the Mid-Semester UG Examinations for Control Systems at the National Institute of Technology Silchar, scheduled for March 2022. It includes a series of compulsory questions covering topics such as differential equations for mechanical systems, block diagrams, signal flow graphs, and RLC circuit analysis. The exam consists of various questions with specified marks totaling 30.

Uploaded by

bisalbiki7
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

National Institute of Technology Silchar

Mid-Semester (UG) Examinations, March 2022


Sub. Code: EC-206, Sub.: Control Systems
Duration: One Hours, Total Marks: 30
Figure in the right-hand margin indicates full marks for the question.
All questions are compulsory.

Q. No. Questions Marks


For a mechanical system shown in figure, write the differential equation
describing its behaviour. Write the analogous electrical equations based on F-
V and F-I analogy.

1(a) 5

1(b) Differentiate Block Diagram and Signal Flow Graph Representation. 2


1(c) Explain any servo system in detail. 3
For the system represented by the block diagram shown below, evaluate the
closed loop transfer function when the input R is
(a) At section A using Block diagram reduction technique.
(b) At section B using Signal Flow Graph Method.

2 10

For an RLC series circuit with, R = 1kΩ, L = 10mH, C = 0.01µF, and input
3(a) voltage as 6V. Determine the natural frequency, and damping ratio of the 5
circuit. Assume zero initial condition.
The block diagram of a unity feedback control system shown in figure.
Determine the characteristic equation of the system, 𝜔𝑛 , 𝜉, 𝜔𝑑 , 𝑡𝑝 , 𝑀𝑝, the
time at which the first undershoot occurs, the time period of oscillations, and
the number of cycles completed before reaching the steady state.

3(b) 5

You might also like