ZAMEL Sp. z o.o., 43-200 Pszczyna, ul. Zielona 27, tel.

: 32 210 46 65; fax: 32 210 80 04 Tested in Poland

e-mail: [email protected], www.zamel.com – Certificate

CTW-03 of Performance

CARBON MONOXIDE DETECTOR CARBON MONOXIDE DETECTOR

CTW-03
It is recommended that the device is installed by Carbon monoxide (CO) is a highly toxic, colourless and odourless gas that easily spreads in the air. Carbon
10
of s years
a qualified individual monoxide is a product of incomplete combustion of certain fuel types, including: wood, furnace oil, earth gas,
petrol, kerosene, propane gas, coal, or petroleum. Carbon monoxide is colourless and odourless; it is then
plik: CTW-03_GB | modyfikacja: 16.04.2020

The present device has been designed to protect

people against severe outcomes of exposure critical to provide early detection and warning of hazardous CO concentration in inhabited rooms.
ser ens
to carbon oxide. However, it is not able to fully vic or
protect persons with special health problems. If FEATURES:
e li
in doubt, consult a physician. • Tested in Poland in a dedicated test chamber: features an additional Certificate of Performance in 300
ppm detection in less than 3 minutes of exposure
fe
Read the User Manual inside the packaging • Carbon monoxide detection levels (ref. standard: PN-EN50291-1:2010+A1:2012: 50 ppm (in up to 90
before installing the detector. minutes); 100 ppm (in up to 40 minutes); 300 ppm (in up to 3 minutes)
Keep the product in a dry place away from • Electrochemical sensor (10 years of service life)

LCD screen
sunlight. Protect • LCD with actual CO
the detector concentration readings
from damage in and user messages
transport and • Battery-operated
while handling; • Low battery indicator Tes
te
• Detector failure indicator – d
of Cer in Po
damage may
reduce the service (self-diagnostic system)
• Past CO detection
P erf tifica land
life.
event memory
orm te
Do not use the a nce
detector if any
damage is evident.

Battery-operated
Power supply: 3 x 1.5 V batteries, type AA; IP20 Do not dispose of this device with other waste! In order to
Net weight:: 0,13 kg avoid harmful effects on the environment and human health,
the used device should be stored in designated areas. For
this purpose, you can dispose of household waste free of

U
charge and in any quantity to a collection point set up, as

se ins
well as to the shop when you buy new equipment.

r M id
Country of origin: PRC

an e
Manufactured for: Zamel Sp. z o.o. by: NDE Ltd.
www.zamel.com

ua
The Declaration of Conformity is available at www.zamel.com

l
CTW-03_GB.indd 2-3 16.04.2020 07:41
 SPECIFICATIONS
• Power supply: 3 x 1.5 V batteries, type: AA
• Sensor design: electrochemical (approx. 10 years of service life)
• Stand-by input current: 35 uA Read the User Manual inside the packaging before installing the detector.
• Alarm mode input current: 85 mA
• Sound level: 85 dB
• Light alarm indication While an installed CO detector greatly improves indoor habitation safety, they are not 100% reliable in CO detection due
• LCD with CO concentration readings and message output to the risks of detector failure, battery depletion and ambient effects. It is critical to periodically test the performance of
• Carbon monoxide detection levels (ref. standard: PN-EN 50291-1:2010+A1:2012): CO detectors (which is specified in this User Manual) and home heating equipment (including stoves, heaters, etc.) and
- 50 ppm (in up to 90 minutes)
inspect all ventilation and flue gas exhaust systems for obstruction in the rooms monitored by CO detectors to minimise CO
- 100 ppm (in up to 40 minutes)
- 300 ppm (in up to 3 minutes)
concentrations that are hazardous to health and life.
• Additional Test Certificate for CO Detection Sensitivity
(300 ppm detected in less than 3 min), tested in a dedicated test chamber
• Ingress protection rating: IP 20
• Operating temperature: 0°C to +45°C
• Operating humidity: 0 to 90% RH
• Dimensions: 140 × 65 × 27 mm 1. ZAMEL Sp. z o.o. grants a 24-month warranty for the products it sells.
Warranty Certificate 2. The warranty granted by ZAMEL Sp. z o.o. does not cover:
24-month commercial warranty granted by a) defects caused by transport, handling or other factors;
1. INSTALLATION ZAMEL Sp. z o.o. b) defects caused by improper installation or operation of the products manufactured ZAMEL Sp. z o.o.;
c) defects caused by any modifications or alterations made by the BUYER or any third party to the sold products or to the
• It is recommended that the device is installed by a qualified individual. equipment required for the proper operation of the sold products;
• Keep the product in a dry place away from sunlight. Protect the detector from damage in transport and while handling; damage may d) defects caused by any force majeure event or another fortuitous event beyond any reasonable control of ZAMEL Sp. z o.o.
e) the power supply (batteries) included (if any) with the product as sold.
reduce the service life. Do not use the detector if any damage is evident. It is recommended to have the product installed by a qualified
3. The BUYER shall submit all warranty claims in writing to the original reseller or to ZAMEL Sp. z o.o.
professional. 4. ZAMEL Sp. z o.o. will examine each warranty claim as regulated by the applicable provisions of the Polish law.
• Install the detector near locations extremely exposed to carbon monoxide concentrations developing from combustion of fuel, e.g. earth 5. If found valid by examination, the warranty claim will be processed by replacement of the defective product, its repair or a refund
gas, wood, or coal. To prevent false detection alarms, install the CO detector at least 2 m from all potential carbon monoxide emission of the price of purchase at the sole discretion of ZAMEL Sp. z o.o.
6. This warranty is only effective on the following territories: Republic of Poland.
sources. 7. No rights of the BUYER arising from the statutory or regulatory laws concerning implied warranty for defects of sold goods are
• Install the CO detector approx. 150 cm above the floor. limited, prejudiced or excluded by this warranty.
• To ensure optimum protection against CO hazards, install CO detectors in all rooms of prolonged inhabitation, especially bedrooms. Install
at least one CO detector per storey in multistorey buildings. Reseller’s stamp and signature with date
• Do not install CO detectors in ‘dead spaces’ (e.g. in recesses closed off by pieces of furniture or curtains, underneath the roof gable, etc.)
and wherever the detection performance will be reduced by currents of fresh air (e.g. near doors, windows, ventilation diffusers or air
fans). Do not install CO detectors in locations highly exposed to airborne dust, aerosols or household chemical which may cause irrepara-
ble failure of the detector.

CTW-03_GB.indd 4-5 16.04.2020 07:41