Scribd
Upload
6 views1 page

Programmable Logic Controllers and Applications Jntuh Mtech

This document outlines the M. Tech II Semester Examinations for Programmable Logic Controllers and Applications at Jawaharlal Nehru Technological University Hyderabad. It includes a list of exam questions covering topics such as the advantages of programmable controllers, PLC system basics, relay ladder logic, and PLC programming. The exam consists of eight questions, with students required to answer any five, each carrying equal marks.

Uploaded by

lecir76948
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views1 page

Programmable Logic Controllers and Applications Jntuh Mtech

This document outlines the M. Tech II Semester Examinations for Programmable Logic Controllers and Applications at Jawaharlal Nehru Technological University Hyderabad. It includes a list of exam questions covering topics such as the advantages of programmable controllers, PLC system basics, relay ladder logic, and PLC programming. The exam consists of eight questions, with students required to answer any five, each carrying equal marks.

Uploaded by

lecir76948
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

U

Code No: 5407AT R17


SE
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
M. Tech II Semester Examinations, July/August - 2021
PROGRAMMABLE LOGIC CONTROLLERS AND APPLICATIONS
(Electrical Power Systems)
D
Time: 3 Hours Max. Marks: 75
Answer any five questions
All questions carry equal marks
PA
---

1.a) List and explain the major advantages of using a programmable controller.
b) Briefly explain the basics of PLC system. [8+7]
PE
2. Explain the overall PLC system with a neat layout and connection diagram with each
functionality. [15]
R
3. For the 2 and 4 input AND gates draw and explain the equivalent relay ladder and PLC
logic. [15]
S
4. Explain the sequential procedural steps involved in Drill press operation along with the
ladder diagram. [15]
JU
5. Write a PLC program for correct operation of: When a start button is depressed, M goes
on. Five seconds later, N goes on. When stop is pushed, both M and N goes off. In
addition, 6 seconds after M and N go off, fan F, which had previously been off goes on.
LY
F remains on until the start button is again depressed, at which time it goes off. [15]

6. Explain in detail about the retentive and off delay timers of the PLC with the required
timing diagrams. [15]
/A
7. Explain the following PLC functions with an example:
a) Sequence functions
U
b) CLR and Sweep. [7+8]
G
8. Explain the concepts of PID tuning and PID functions. [15]
-2
---oo0oo---
02
1

You might also like