Scribd
Upload
5 views5 pages

打开"HW2"

The document contains a series of questions related to electrical circuits involving diodes, including calculations for output voltages, currents, and resistor values. It also asks for sketches of I-V curves and DC load lines, as well as the design of a clipper circuit. Each question requires application of the exponential model for diodes and circuit analysis techniques.

Uploaded by

h5knbhzy4j
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
5 views5 pages

打开"HW2"

The document contains a series of questions related to electrical circuits involving diodes, including calculations for output voltages, currents, and resistor values. It also asks for sketches of I-V curves and DC load lines, as well as the design of a clipper circuit. Each question requires application of the exponential model for diodes and circuit analysis techniques.

Uploaded by

h5knbhzy4j
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Q1

Determine the value of Vo1 , Vo 2 , and I for the network below.

Q2
Given that both diodes in the circuit are identical, and they conduct 10 mA current at 0.7 V
and 100 mA at 0.8 V. Find the value of R that will produce an output voltage of 80 mV, with
the exponential model.

Q3
Given that the diode has VT = 25 mV, n = 1, and I S =1 pA, use the exponential model to
(a) Sketch the diode’s I-V curve and the DC load line.
(b) Determine the DC current I D and the output voltage VR for the circuit with E  10V

and R  1kΩ .
x 2 x3
(Hints: ln(1  x)   x    )
2 3

Q4
For the network below, sketch vo and iR .

Q5
Design a clipper to perform the function indicated in the figure below. Use only one diode，
one resistor and one DC voltage supply.

You might also like