Scribd
Upload
20 views10 pages

Final Problem Set

The document outlines a series of problems related to JFET and MOSFET circuits, requiring calculations for parameters such as VDD, VGS, ID, and Q-point. It includes tasks for determining operating points, characteristic curves, and voltage gains in various configurations. The problems involve applying specific JFET and MOSFET parameters to analyze circuit behavior and performance.

Uploaded by

KEVIN EDUARD VILLANUEVA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
20 views10 pages

Final Problem Set

The document outlines a series of problems related to JFET and MOSFET circuits, requiring calculations for parameters such as VDD, VGS, ID, and Q-point. It includes tasks for determining operating points, characteristic curves, and voltage gains in various configurations. The problems involve applying specific JFET and MOSFET parameters to analyze circuit behavior and performance.

Uploaded by

KEVIN EDUARD VILLANUEVA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 10

1. For the JFET shown below, with VGS(OFF)= -4V and IDss = 12 mA.

Determine the minimum value of VDD required


to put the device in the constant-current region of operation when V GS= 0V.
2. Find VDS and VGS in the circuit shown. For the particular JFET in this circuit, the parameter values
such as gm, VGS(off) , and IDSS are such that a drain current (ID) of approximately 5 mA is produced.
given that for this particular JFET the parameter values are such that V D≅7 V.
3. Determine ID and VGS that for this particular for the JFET with voltage-divider bias in the circuit shown,
4. Determine the approximate Q-point for the JFET with voltage-divider bias in the circuits shown. Idss=12mA
and Vp=-3V. Plot the characteristic curve.
5. Determine VGS and VDS for the E-MOSFET circuit shown. Assume this particular MOSFET has minimum
values ID(ON)= 200mA at VGS=4V and VGS(TH)=2V.
6. The circuit shown below find: (a) IDQ and VDSQ (b) VDS and VS
7. The fixed bias configuration circuit shown had an operating point defined by V GSQ=-2V and IDQ=5.625mA,
with IDSS=10mA and Vp= - 8V. The value of ������=40����. Determine the following:
a. gm
b. rd
c. Zi
d. Zo
e. Av
f. Av ignoring the effects if rd
8. Dertmine I and Vout.

9. What is the required value of R for a voltage gain of 10. Determine Vout.

You might also like