0% found this document useful (0 votes)
100 views3 pages

GT20 Quick Use Instruction

The document provides instructions for preparing and installing a 4G SIM card in a GPS tracking device, including necessary configurations for data upload and SMS functionality. It outlines the wiring definitions, device configuration settings, and troubleshooting steps for LED indicators. Additionally, it includes commands for setting the APN, checking parameters, and managing the device's relay functions.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
100 views3 pages

GT20 Quick Use Instruction

The document provides instructions for preparing and installing a 4G SIM card in a GPS tracking device, including necessary configurations for data upload and SMS functionality. It outlines the wiring definitions, device configuration settings, and troubleshooting steps for LED indicators. Additionally, it includes commands for setting the APN, checking parameters, and managing the device's relay functions.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Ⅰ.

PREPARE QUALIFIED SIM CARD


A micro 4G SIM card with GPRS network is 2.3 You need to choose somewhere that it won't be
required. And this SIM card should have the SMS & found, below are suggested position, avoid water,
Caller ID function& enough deposit, so that it can shock and interference.
upload the data to the server and able to send
SMS.
Ⅱ.INSTALLATION
Please insert the SIM card to the device,and
then connect to the car or DC power adapter, it will
turn on automatically, support 9-90V.

2.1 Wire Denfination

No Colour Interface Definition


1 White Oil -
2 Orange ACC
3 Black Power GND
4 Red Power +

2.2 Wire connection

Low Battery Alarm GT20


Real-Time Tracking
Historical Tracking
Cutoff Petrol/Electric 4G GPS Tracker
ACC/Ignition Detection
Geo Fence in/out Alarm
1 Blind Spot Storage
2
Ⅲ.DEVICE CONFIGURATION,SYMBOL Ⅴ.CHECK LED INDICATOR WORKING STATUS Ⅶ.TROUBLESHOOTING
3.1 Set IP and port If these 3 conditions are
met at the same time,the
3.1.1 If use your own server,Settings can be red light will always be on. Problem Reason Solution
completed by sending the following SMS If none of the three Sim Card No
Recharge Money
command. conditions occur, the light Money
For example,you IP and port is 123.31.43.207,8208 External will not light up Sim Card
Please Install Sim
Then should send : GSM + GPS, no external Connect Good
power Card Again
SERVER,8520,123.31.43.207,8208# power supply, red light Or Not
connect, flashing quickly Reset Parameters
Center Online
3.1.2 If use use GREAT WILL SERVER,send format With Correct
Indicator GSM External power connection Cannot Parameter
as below: Format According
+ GSM network, no GPS , Monitor Setting Error
Command format(Set IP),send : network, To User Manual
red light flashing normally Vehicles Are In
SERVER,8520,103.44.239.100,88# GPS
Command format(Set Domain),send : Underground Leave Off The
SERVER,8520,www.gpsgreat.com,88# position GPS positioning + external Parking Lots, District With Weak
power supply is normal Tunnels, Weak Signal
Ⅳ.SET LOCAL APN No GSM signal, the Signals
4.1 Without user name and password: Send SMS indicator light flashes Wrong Installation Install The Device
command:APN,cmnet# slowly. Light Location Is In In Area Without
Alarm Light Area Light
4.2 If with user name and password: After above necessary configurations, if all Led Vehicle In
APN,network name[,account, password]# indicators long/flash bright,put device in open Underground
Leave That Area
window or install to vehicle for following usage. Car Parks Or
Cannot
Tunnels
Locate
For example: GPS Antenna Make The Gps
Ⅵ.ONLINE TRACKING SYSTEM
APN,intenet,123,123# Side Is Not Up Antenna Side Up
You can review or real-time monitoring the
To Sky To Sky
vehicles via www.gpsgreat.com. Or search
“GPSGREAT” in Google Play or Apple Store to
download App and login with the account and
password given by dealers.

4
3 5
Ⅷ.OTHER COMMON USE COMMAND

①Set Time Zone


Command format: ④Reset Device
GMT,Bearing,Time Zone(,Half Time Zone)# Command format:RESET#

For example If send this command ,then it will restart after


1) GMT,E,8# 20sec
2) GMT,W,6#

②Check Parameters ⑤Disable And Enable Relay


Command format:PARAM# RELAY control the start and closeness of relay

IMEI:351190012535936 IMEI Command format:RELAY,1# (stop engine)


Command format:RELAY,0# (restore engine)
APN:cmnet APN
IP:www.gpsgreat.com:88 IP and port The device only cut off the oil circuit on the
CENTER:Apply setting center number condition of the driving speed below 20KM/H

TIMER:10S moving uploading interval


LANGUAGE:EN language(CN/EN)
GMT: E8 time zone(E/W)

③Check Version
Command format:VERSION#

Reply:VERSION:Xxxx
BUILD:2012-07-05 10:12
More details please refer to the user manual!

Leader in Vehicle
7
GPS Tracking
6 &
Video Recording

You might also like