BP Tank Cleaning Guide

General application to avoid quality degredation, no consideration is made for individual Port Regulations

MTBE/ETBE/TAME/Ethanol/Methanol

Low Sulphur Fuel Oil (LSFO / LSWR)

Naphtha / Clean Condensates / LDF
Previous

Wax Distillate / Vacuum Gas Oil

Crude Oils / Dirty Condensates
Cargo

Sulphur Free Diesel / ULSD

Sulphur Free Motor Spirit

Heavy / Medium Fuel Oil

Jet / Aviation Kerosenes
Unleaded Motor Spirit

Kerosenes (undyed)

Atmosphric Residue
Leaded Motor Spirit

Light Fuel Oil (LFO)

Kerosenes (dyed)

Gas Oil (undyed)

Gas Oil (dyed)

Lube Oils
Biodiesel
Cargo to

Solvents
Avgas

FAME
be Loaded

Naphtha/Clean Condensates/LDF
Avgas
MTBE/ETBE M M M M M M M M M M M
Ethanol/Methanol 6 M M M M M M M M M M M
Leaded Motor Spirit
Unleaded Motor Spirit
Sulphur Free Motor Spirit
Solvents PM PM PM PM PM PM PM PM D M M M
Jet / Aviation Kerosenes PM PM PM PM PM PM RM M RM M RM M M D M
Kerosenes (undyed) P P P P P
Kerosenes (dyed) P P P P P
Un-dyed Gas Oil P P P P P P P
Dyed Gas Oil P P P P P P P
FAME / Biodiesel M M M M M M M M M M M M M M M
Ultra Low Sulphur Diesel/Gas Oil PM PM PM PM PM PM PM PM M M
Sulphur Free Diesel PM PM PM PM PM PM PM
Crude Oils / Dirty Condensates
Lube Oils PM PM PM PM PM PM PM M LUB
Wax Distillate / Vacuum Gas Oil P P P P P PX
Atmospheric Residue P P P P P PX
Heavy / Medium Fuel Oil PX PX PX PX P PX
Low Sulphur Fuel Oil (LSFO / LSWR) PX PX PX PX P PX
Light Fuel Oil (LFO) PX PX PX PX P PX X X X

THIS GUIDE COVERS WHITE OIL CARGOES IN COATED TANKS.

AND BLACK OIL / CRUDE CARGOES IN EITHER COATED OR UNCOATED TANKS.
P Tanks to be purged to below 2% Hydrocarbon by volume
No washing required - strip and drain wel Non IG Vessels should be 'Gas Free'
Refer Notes: 1 & 2 M Tanks to be mopped or educted DRY

X If ROB is less than 0.1%, and purging (if required) is effective

Wash tanks with COLD sea water until tank is clean cargo may be loaded directly on top without washing
Refer Notes 1, 2 & 3
Tanks that have been washed for the carriage of these products must have a fina
wash with fresh water. Tanks and lines are then to be blown and drained of wate
Wash tanks with HOT sea water until tank is clean.
Refer Notes 1, 2 & 3 LUB To ensure minimum grade to grade admixture, tanks to be stripped dry, pump column
and deck lines to be blown and drained. Tanks to be visually inspected for min ROB

Product NOT to be loaded unless specific instructions R Fresh water rinse required only, lines and pumps drained of water.
have been issued by BP Head Office

Notes: 1. Tanks to be stripped dry such that any liquid ROB is confined to the pump well - or better
2. Pump columns, deck lines, drops etc are to be blown clear and drained free of all product and wate
3. Deck lines, loading drops and cross over lines must be thoroughly washed and drained
4. MTBE/Methanol/Ethanol (oxygenates) Are water miscible, introduction of water into designated tanks should be avoided
5. These tank cleaning guidelines are guidelines only and not to be regarded as BP instructions to inspector
6. Phenolic epoxy coatings are suitable for methanol carriage

09/02/2007