Scribd
Upload
29 views1 page

Web Card

The document provides commands for enabling web access on a device using the APC command line interface. It includes steps to set the web ports and reboot the device to apply changes. Additionally, it suggests changing the FTP port to 21 and rebooting again to save the configuration.

Uploaded by

Khalid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views1 page

Web Card

The document provides commands for enabling web access on a device using the APC command line interface. It includes steps to set the web ports and reboot the device to apply changes. Additionally, it suggests changing the FTP port to 21 and rebooting again to save the configuration.

Uploaded by

Khalid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Type web help

If you have the same , then Just send command as below

apc> web -h enable

apc> web -s enable

apc> web -ph 80

apc> web -ps 443

apc> reboot

once reboot completed, try to go/access webpage by entering the IP Address (this should work now)

then change also below “Enable” then Port “21” then Reset/Reboot to save changes

Internal

You might also like