Scribd
Upload
2 views

Ch1-Circ

The document contains a quiz consisting of 10 questions related to magnetic fields, current, and electrical circuits. Each question presents multiple-choice answers regarding concepts such as magnetic flux density, magnetic permeability, and the behavior of wires in magnetic fields. The quiz is designed to test knowledge on electromagnetic principles and calculations.

Uploaded by

Hady Ebraheem
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2 views

Ch1-Circ

The document contains a quiz consisting of 10 questions related to magnetic fields, current, and electrical circuits. Each question presents multiple-choice answers regarding concepts such as magnetic flux density, magnetic permeability, and the behavior of wires in magnetic fields. The quiz is designed to test knowledge on electromagnetic principles and calculations.

Uploaded by

Hady Ebraheem
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

10

QUIZ ON LECTURES (1  5)
(1) It is the magnetic flux density, which exerts a force of one Newton on a wire carrying
a current of one Ampere, of length one meter, and placed perpendicular to the
magnetic flux lines: (a) Weber. (b) N.m/A. (c) Tesla. (d) None of the previous.
(2) Two parallel long straight wires, they carry equal currents I. The distance between
the two wires is doubled. In order to maintain the magnitude of the mutual force
between them as its original value, the current intensity through each wire should be
I
modified to be: (a) . (b) I 2 . (c) 2 I. (d) 4 I.
2
(3) The SI unit of magnetic permeability is:
(a) Wb.m−2.A−1. (b) Wb.m−1.A (c) Wb.m−1.A−1. (d) Wb.m.A−1.
(4) A long solenoid has 200 turn per cm and carries a current I. The magnetic field at
its center is 6.28 × 10-2 Weber/m2. Another long solenoid has 100 turns per cm and it
carries a current I . The value of the magnetic field at its center is:
3
(a) 1.05 × 10-2 Weber/m2. (b) 1.05 × 10-5 Weber/m2.
(c) 1.05 × 10-3 Weber/m2. (d) 1.05 × 10-4 Weber/m2.
(5) In the opposite figure (In the following attachment),
the total magnetic flux density at point a equals:
(a) 2.5  10-6 T. (b) 3.33  10-6 T.
(c) 2.56  10-5 T. (d) None of the previous.

(6) A wire is placed parallel to the lines of force in a magnetic field and a current flows
in the wire. Then:
(a) The wire will experience a force in the direction of the magnetic field.
(b) The wire will not experience any force at all.
(c) The wire will experience a force in a direction opposite to the field.
(d) It experiences a force in a direction perpendicular to lines of force.
(7) In the shown figure (In the following attachment) a circular
ring of diameter 2 cm is connected to a battery of e.m.f. 12 V
and internal resistance 2 , knowing that the resistance of the
ring 16  . Therefore the flux density at the center of the ring
m when the switch K is open equals: (air = 4 π × 10-7 Wb/A.m.)
(a) 3.34  10-4 T. (b) 2.89  10-5 T.
(c) 4.77  10-5 T. (d) None of the previous.
(8) A straight wire of diameter 0.5 mm carrying a current 2 A is replaced by another
wire of diameter 1 mm carrying the same current. The strength of magnetic field at a
distance 2 m away from the centre is: (a) Half of the previous value.
(b) Twice of the previous value. (c) Unchanged. (d) Quarter of its previous value.
(9) Two batteries one of the e.m.f. 3 V, internal
resistance 1 Ω and the other of e.m.f. 15 V, internal
resistance 2 Ω are connected in series with a
resistance R as shown. If the potential difference
between points a and b is zero, the resistance R in Ω
is: (a) 5 (b) 7 (c) 3 (d) 1
(10) An Aluminum wire XY of cross-sectional area 0.1 cm2 is
held horizontally while its terminals are in contact to the ends
of an electric circuit as shown in the opposite figure (In the
following attachment). Therefore the density of the magnetic
flux that keeps the wire suspended without any external support
equals: (Al = 2700 Kg/m3, g = 10 m/s2)
(a) 16  10-3 Tesla. (b) 27  10-3 Tesla. (c) 36  10-3 Tesla. (d) None of the previous.

You might also like