Scribd
Upload
3 views

Tutorials-1-EEE

The document outlines a series of electrical engineering problems, including the design of a zener regulator, calculations of power change in decibels, output voltage of an amplifier, and performance metrics of rectifiers and transistors. Specific parameters such as voltage, resistance, and frequency are provided for each problem. The document serves as a tutorial for students to apply theoretical concepts in practical scenarios.

Uploaded by

kalilinuxkishore
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
3 views

Tutorials-1-EEE

The document outlines a series of electrical engineering problems, including the design of a zener regulator, calculations of power change in decibels, output voltage of an amplifier, and performance metrics of rectifiers and transistors. Specific parameters such as voltage, resistance, and frequency are provided for each problem. The document serves as a tutorial for students to apply theoretical concepts in practical scenarios.

Uploaded by

kalilinuxkishore
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

TUTORIAL-1

1. Design zener regulator for given specification.

Vin varies from 15V to 18V


RL varies from 225Ω to 2KΩ
VZ=9V
IZ(min)=10mA
Pd(max)=4.5W

2. The output power from an amplifier is 50mW when the signal frequency is 5KHz. The
output power falls to 25mw when the freq is 20 KHz. Calculate the power change in decibels.
3. An amplifier has a voltage gain of 100 at 1KHz. The gain falls by 6dB at 1MHz, if the
input is 3mW at 2MHz. calculate the output voltage.
4. A full wave bridge rectifier supplies a load of 2Kohm, the AC voltage applied is 200 V at
the secondary of transformer. If capacitor of 500 microF is connected across the load, find i)
Ripple factor ii) DC output voltage iii) DC load current iv) % of regulation.
5. A bridge rectifier has a supply 20 V to a 500 ohm load, the peak to peak ripple should not
exceed 10% of average output voltage and the AC input frequency is 60 Hz. Calculate the
capacitor value.
6. A silicon transistor has its Ico=6nA and α=0.98. If Ib=0 and Vce= 4V then
Ic=---------------
An NPN transistor has lco=30nA, Ib=0, Vce=4V and Ic=30uA .The value of β=-------------
7. a)Three amplifiers of voltage gain 20dB, 26dB and 32dB are cascaded to obtain an output
voltage of 2V. Calculate the input voltage needed.
b) An amplifier having a power gain of 17dB delivers a power output of 40W to a load of
1KΩ. Calculate i) the input power needed and ii) the input voltage needed, if the voltage gain
of the amplifier is 38dB.

You might also like