Scribd
Upload
13 views1 page

Fluid Mechanics Problem Set 1

Uploaded by

Dominic Papa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
13 views1 page

Fluid Mechanics Problem Set 1

Uploaded by

Dominic Papa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

University of the Philippines Diliman

Institute of Civil Engineering

ES 15: MECHANICS OF FLUIDS


Problem Set 1
First Semester, A.Y. 2017-2018
General Instruction: This problem set is not a course requirement but answering all questions to
the best of your knowledge is highly encouraged to prepare you for the long exam. If you have any
question regarding any item in this problem set, email me at [email protected].

Problem 1

The reading of an automobile fuel gage is proportional to the gage


pressure at the bottom of the tank. If the tank is 20 cm wide, 32 cm
deep and is contaminated with 3 cm of water, how many
centimeters of air remains at the top when the gage indicates “full”?
Calculate also the magnitude of the resultant hydrostatic force on
the right side of the tank. Use γgasoline = 6670 N/m3.

Answer: h = 1.412 cm; F = 46.437 N

Problem 2

Determine the minimum volume of concrete (SGconcrete = 2.40) needed


to keep the 1-meter wide gate in a closed position in the condition
where l = 2 meters.

Answer: 0.381 m3

Problem 3

The hemispherical gate is held in position by a cylindrical buoy.


Determine the minimum required depth of submergence of the
buoy to keep the gate closed. The fluid is water. Neglect the
weights of the gate and the buoy. NOTE: There is no fluid below the
gate.

Answer: 0.583 m

Problem 4

An open cylindrical tank 1.2 meters in diameter and 2.1 meters high is 2/3 full of water. After rotating with a
constant angular speed, ω, about its vertical axis, the water depth at the tank became 0.9 meters when put
back to rest. What is the value of ω?

Answer: 11.56 rad/s

-o- end of problem set -o-


1 of 1
ES 15 Problem Set 1 DMB

You might also like