Scribd
Upload
31 views3 pages

Ect202 Analog Circuits, June 2022

ktu 2019 scheme analog circuits paper

Uploaded by

tve22ae062
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views3 pages

Ect202 Analog Circuits, June 2022

ktu 2019 scheme analog circuits paper

Uploaded by

tve22ae062
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

02000ECT202052104

Reg No.:, Name:

Course Code: ECT202


Course Name: ANALOG CIRCUITS
Max. Marks: 100 Duration: 3 Hours
PART A
(Answer all questions; each question carries 3 marks) Marks

Draw the circuit of an RC integrator. Give the conditions for an RC circuit to


act as integrator.
Define Stability factor. Derive the expression for stability factor ‘S’.
Differentiate between dc and ac load lines.
What is the significance of Miller effect on high frequency amplifiers?
Given K=0.4mA/V? and Ipon) = 3.5mA with Vgson) = 4V. Determine the
value of V.
What are the effects of cascading in gain and bandwidth of an amplifier?

W
Differentiate positive feedback and negative feedback.

W
Draw the block diagrams of current series and current shunt feedback.

W
Illustrate the principle of output current boosting circuit in a voltage regulator?
What do you mean by crossover distortion? How can it be eliminated? oW
W

PART B
(Answer one full question from each module, each question carries 14 marks)
Module -1
Given an input wave, Vin=10sinwt. Setup and explain a clamper that clamps
a)
the wave to 22.3V at the positive peak, assuming a voltage drop of 0.7 V across
the diode. Draw the output waveform and transfer characteristics also.
1
Design a fixed bias circuit for a CE amplifier such that operating point is Vcg =
b) 8V and Ic=2 mA. Given, a fixed 15V d.c. supply and a silicon transistor with 8
= 100. Take base-emitter voltage Ve = 0.6V and neglect Rg.
12 a) With n;x:essary diagrams, explain any two biasing methods of BJT.
Set up and explain a slicer circuit that clips an input sine wave at +2V and +4V.
b)
Draw the transfer characteristics.

Pagelof3

DOWNLOADED FROM KTUNOTES.IN


02000ECT202052104

Module -2
Analyse the high frequency
a response of an amplifier
in CE configuration using
13) hybrid 7 model.

b) Draw and explain the frequency


response of RC coupled
amplifier.
Using hybrid model, calculate the small 6
signal voltage gain, input
and output impedance of impedance
the given circuit.
Given,VaE=0.7V, Va=80V,
Ic = 2mA and B=100. (Neglecting
ro)

14
14

Vin
100mv

Module -3
Draw the CS stage with
a) diode connected load and
deduce the expression for
voltage gain of the amplifier, 8
Calculate the drain current
and drain-to-source voltage
of a common source
circuit with an n-channel
enhancement mode MOSFET.
Find the power
dissipated in the transistor.
Ri=22KQ, Rz=10!_(§l, Rp=6.8KQ,
1 Vpp=8v, V=1V, Kn=0.1mA/V?2
. Yoo

b)
6
Rp
*
Ve Vos

Page20f3

DOWNLOADED FROM KTUNQTES.IN


02000ECT202052104

Draw the circuit of a common source amplifier using MOSFET. Derive the

a) expressions for voltage gair'l, input resistance and output resistance from small’
16
signal equivalent circuit.
b) Briefly explain a Cascode amplifier.
Module -4
With neat circuit diagram, explain the discrete BJT circuit in voltage-series
17 feedback and derive the expression for voltage gain, input impedance and
output impedance.
a) Design wein-bridge oscillator using BJT to generate 1KHz sine wave.
18
b) With neat circuit diagram, explain the working of Hartley oscillator
Module -5
What are the factors affecting the variation in output voltage of voltage
19 - regulator? With a circuit diagram, explain how load and line regulations are 14
achieved in a shunt voltage regulator.
Explain the working of Class B push-pull power amplifier with a neat circuit
20 14
diagram and output waveforms. Derive the expression for collector efficiency.
*x
b

Page3of3

DOWNLOADED FROM KTUNOTES.IN

You might also like