Scribd
Upload
42 views1 page

Position Coder Newer Style

The document outlines troubleshooting steps for issues related to thread cutting operations, specifically when the position coder does not rotate. It details potential causes such as a broken timing belt or a faulty position coder, and provides guidance on checking connections and signals. Additionally, it mentions the implications of a feedrate command set to 0 and its relation to alarm settings.

Uploaded by

mark
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
42 views1 page

Position Coder Newer Style

The document outlines troubleshooting steps for issues related to thread cutting operations, specifically when the position coder does not rotate. It details potential causes such as a broken timing belt or a faulty position coder, and provides guidance on checking connections and signals. Additionally, it mentions the implications of a feedrate command set to 0 and its relation to alarm settings.

Uploaded by

mark
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

B–63525EN/02 11.

TROUBLESHOOTING

(c) Thread cutting does not operate


1) Position coder does not rotate
Check the connection between spindle and position coder
The following failure is considered:
⋅ Timing belt is broken
⋅ Key is removed
⋅ Coupling is loose
⋅ Connector of signal cable is loosened
2) Position coder is faulty
Position coder is connected to the spindle amplifier when serial
interface spindle is used or connected to the CNC when analog
interface spindle is used.
For details of connection, refer to the following.
<T series>
Whether A/B phase signals from the position coder are read
correctly, can be judged also by the spindle speed display on the
CRT screen (position screen). (However, it is not displayed
when PARAM 3105#2=0).

<αi series spindle amplifier>

CNC Position
coder
JA7B JYA3
JA41
SPM
JA7A Spindle
motor
Position
coder
JA7B JYA3
SPM
JA7A Spindle
motor

<Analog interface spindle amplifier>

CNC
JA41 Position
coder

Analog spindle Spindle


JA40 motor
amplifier

(d) A cutting feed block containing a feedrate command (F command)


with a feedrate of 0 is specified.
If FCO (bit 7 of parameter No. 1404) is set to 1, P/S alarm 11 is not
issued even if a feedrate command (F command) with a feedrate of
0 is issued.

747

You might also like