Scribd
Upload
9 views2 pages

Me 11

The document is a laboratory experiment manual for studying the characteristics of an Instrumentation Amplifier using a 3 Op-amp configuration. It outlines the objectives, circuit diagram, and detailed procedures for measuring differential gain, common mode gain, and frequency response. Additionally, it includes instructions for using a single chip Instrumentation Amplifier AD624.

Uploaded by

Chandrali Das
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views2 pages

Me 11

The document is a laboratory experiment manual for studying the characteristics of an Instrumentation Amplifier using a 3 Op-amp configuration. It outlines the objectives, circuit diagram, and detailed procedures for measuring differential gain, common mode gain, and frequency response. Additionally, it includes instructions for using a single chip Instrumentation Amplifier AD624.

Uploaded by

Chandrali Das
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Measurements & Electronic Instruments Laboratory Experiment Manual

Department of Electrical Engineering, I.I.T. Kharagpur

INSTRUMENTATION AMPLIFIER

Objective: To study the characteristics of an Instrumentation Amplifier.


Circuit diagram:

The circuit diagram of a 3 Op-amp. Instrumentation Amplifier is shown in Fig-


1. The output voltage can be expressed as,
𝑉 (1+ 𝑉 𝑉

The differential gain can be adjusted by varying R2. The main advantage of an
Instrumentation Amplifier, (i) High differential gain, (ii) Large common mode
rejection, (iii) High input impedance and (iv) Moderate bandwidth.

[1]
Procedure:

1. Construct the Instrumentation Amplifier as shown in Fig-1. This circuit


will provide approximately a differential gain of 100. Use 1% tolerance
resistances.
2. Connect the two input terminals to ground and measure the DC offset
voltage at V0. If required reduce the offset by using offset adjustments of
Op-amps.
3. Connect both the input terminals to +5V and note output due to the
common mode voltages. Compute the DC common mode gain.
4. Compute the small signal AC differential gain using the circuit in Fig-2
as follows:

The circuit will provide approximately Vi1 – Vi2 = 0.01V1. Apply 1V p-p
Sin wave from the function generator at 10Hz, 100Hz, 1 kHz, 10 kHz
and 100 kHz observe the output V0 by Oscilloscope. Compute differential
gain Ad for different frequencies. Plot the frequency response.
5. Compute the Ac common mode gain Ac by removing R5 and R6 in Fig-2,
at difference frequency mentioned above. Apply V1 = 10V p-p. Compute
CMRR for all the frequencies.
6. Study the pin configuration and performance of a single chip
Instrumentation Amplifier AD624.

[2]

You might also like