PRODUCT tec bond is a co-polymer acrylic emulsion designed to prime absorbent concrete substrates prior to the application of fresh concrete. It seals pores on concrete surfaces to prevent air bubbles rising through freshly applied concrete and prolongs its flow life and workability.
SCOPE OF USE Bonding fresh concrete over cement based renderings, substrates made of concrete, light concrete, wooden-like panels, ceramic tiles and asphalt concrete.
CHARACTERISTICS Density Approx. 1 kg / lit Min.overlay time 1/2 to 2 hours depending on application rate and climatic conditions PACKAGING Max.overlay time 24 hours Leb Syria Jordan UAE Qatar Kuwait KSA Oman Slant shear bond > 4 MPa 5 lit 5 lit 20 lit 5 lit 5 lit 5 lit 5 lit 5 lit strength (ASTM C1042) 15 lit 15 lit 15 lit 15 lit 15 lit 15 lit 15 lit 15 lit
APPLICABLE STANDARDS ASTM C 1059 COVERAGE INSTRUCTIONS FOR USE 100 to 300 ml/m2 depending on the roughness and absorbency SUBSTRATE PREPARATION of the substrate. The substrate must be perfectly sound, clean, and free from grease, oil, dust or any friable matters. Depending on type and condition of substrate, a mechanical STORAGE treatment (e.g. mechanical brushing, grinding or sanding) is tec bond has high storage stability from - 20°C to + required. Intensity of such work needs to be determined at 45°C. Always stir before use. site. Dust, paint, residual adhesives or other surface pollution Can be stored for up to 6 months after manufacturing date, must be removed by suitable means. We recommend in original packaging. cleaning the surface with an industrial vacuum cleaner. SAFETY PRECAUTIONS PRODUCT APPLICATION Avoid prolonged contact with skin. Wear protective gear for Shake container well before use. Apply the bonding agent hands & eyes. Splashes on the skin should be washed away evenly, using a brush, roller or small broom, over the sound, by cleaning with soap and water. In case of contact with eyes, clean and dust-free surface and leave to dry to a clear thin wash thoroughly with clean water. If swallowed, do not induce film before covering with the fresh concrete. Re-priming is vomiting; in both cases seek medical attention. The product is necessary if 24 hours passes without covering. non-flammable. It is important that the bonding agent fill every square inch of the substrate to ensure a solid bond of the fresh mix. Avoid DISCLAIMER the formation of puddles. While the company guarantees its products against defective Extremely porous substrates may require two priming coats. materials, the use and application of these products are Clean tools with water before they dry. made without guarantee since the conditions of their application are beyond its control. It is recommended to verify with the company that the product is suitable for the intended use, and that this Data Sheet version is the latest one. The company
1/2 Technical data sheet . Edition: 10.16-A www.sodamco-weber.com
tec bond TECHNICAL AND REPAIR MORTARS
may modify it without prior notice. Technical characteristics
are listed for guidance only. For more information, please contact the company’s office in your location.
NOTE The information included on this Technical Data Sheet is the sole property of SODAMCO Holding. The unauthorized disclosure, use, dissemination or copying (either whole or partial) of this data sheet or any information it contains, is prohibited and subject to legal pursuit.
PG:29
2/2 Technical data sheet . Edition: 10.16-A www.sodamco-weber.com
