Scribd
Upload
32 views1 page

Check List 2 FM200

The document outlines a commissioning checklist for the HFC-227ea or FM-200 system at the Rove Hotel in Ras Al Khaimah. It includes a series of functional tests and visual inspections to ensure the mechanical system operates correctly, detailing specific requirements for alarm indications and system responses. The checklist is intended for use by various engineering and quality assurance personnel involved in the project.

Uploaded by

1freelancersc
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
32 views1 page

Check List 2 FM200

The document outlines a commissioning checklist for the HFC-227ea or FM-200 system at the Rove Hotel in Ras Al Khaimah. It includes a series of functional tests and visual inspections to ensure the mechanical system operates correctly, detailing specific requirements for alarm indications and system responses. The checklist is intended for use by various engineering and quality assurance personnel involved in the project.

Uploaded by

1freelancersc
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

PROJECT: CLIENT: ENGINEER:

ROVE HOTEL AT PLOT 1 APT.001, AL ROSE HOTELS FZ LLC ARCH GROUP


MARJAN ISLAND, RAS AL KHAIMAH
MAIN CONTRACTOR MEP CONTRACTOR Inspection Req No:
Rev:00
Date:
COMMISSIONING CHECKLIST
FOR HFC-227ea OR FM-200 SYSTEM -( FUNCTIONAL TEST )
Drawing
Location: Ref:

Mechanical System - Visual Inspection.


S. No. Test Functional Requirement YES NO
1
Panel shall show trouble indication, internal
Remove one Detector from zone buzzer ON, LED display shall display the
Zone No

2
Make an open Circuit in any of 3 Panel shall show trouble indication,
Alarm indicating circuits of release internal buzzer ON LED display shall display
circuit the description of device
3
6” Alarm bell should ring. Alarm LED on.
Activate one, Smoke detector in LED display shows Zone no. Signal to mail Fire alarm
either circuit panel.

4
Strobe horn on.
Activate 1 No. of detector from Pre-discharge LED on.
another circuit while first one in Starts countdown of time delay. Signal to main Fire
Alarm condition alarm panel.
Signal to shutdown A/C unit, Drop curtain.

5 Release indication on panel.


At the end of Set Time Delay LED ON AND ARM ON Warring light On.
6
Stimulate Cross zone condition and ‘Abort’ Indicates on Panel
within set time delay actuate ‘Abort LED display shows the circuit no. Countdown halted till
Switch’ time abort is active.

7 No. 4 & 5 occur without any time delay


Functional requirements of Sl
Activate
8
low pressure switch on Cylinder Supervisory LED ON on Panel. LED display shows the
Location Test Make an circuit no. Panel internal buzzer on.
Comments / Remarks (If Any):

Specialist Engineer CSCEC MEP Engineer CSCEC MEP QAQC ARCH GROUP

Name

Signature

Date

You might also like