Scribd
Upload
15 views4 pages

Tutorial-Maximum Tranfer

The document contains a series of electrical engineering problems focused on applying Norton’s and Thevenin’s theorems to calculate maximum power transfer, equivalent capacitance, and energy stored in capacitors. It includes specific tasks such as finding resistor values for maximum power, calculating currents, and determining capacitance based on charge and voltage. Additionally, it addresses the behavior of capacitors and inductors in steady state conditions.

Uploaded by

inesh100
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
15 views4 pages

Tutorial-Maximum Tranfer

The document contains a series of electrical engineering problems focused on applying Norton’s and Thevenin’s theorems to calculate maximum power transfer, equivalent capacitance, and energy stored in capacitors. It includes specific tasks such as finding resistor values for maximum power, calculating currents, and determining capacitance based on charge and voltage. Additionally, it addresses the behavior of capacitors and inductors in steady state conditions.

Uploaded by

inesh100
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

1.

Applying Norton’s theorem, calculate the value of R that results in


maximum power transfer to the 6.2Ω resistor. Find the maximum
power dissipated by the resistor 6.2Ω under that situation

2. Find the equivalent capacitance seen at the terminals of the circuit

3. Compute the value of R that results in maximum power transfer to the


10- resistor. Find the maximum power.

4. Find the value of RL for maximum power transfer and compute the
maximum power delivered
5. (a) For the circuit below, obtain the Thevenin equivalent at terminals a-
b.
(b) Calculate the current in RL = 8Ω.
(c) Find R L for maximum power deliverable to RL.
(d) Determine that maximum power.

6. If an 8-kΩ load is connected to the terminals of the network, VAB


connected to the terminals, VAB=16 Ω. If a 2-kΩ load is VAB = 8 V .
Find VAB if a 20-kΩ load is connected to the terminals.
7. Find the value of RL in the network for maximum power transfer to this

load.

In dc steady state, a capacitor looks like an open circuit and an inductor


looks like a short circuit.

8. A capacitor has an accumulated charge of 600 C with 5 V across it.


What is the value of capacitance?

9. Given the network, find the power dissipated in the 3 ohms resistor
and the energy stored in the capacitor.
10. Select the value of C to produce the desired total capacitance of
CT = 10 F in the circuit

11. The two capacitors were charged and then connected as shown.
Determine the equivalent capacitance, the initial voltage at the
terminals, and the total energy stored in the network.

You might also like