Scribd
Upload
16 views4 pages

02 - How To Create A New Project - IDEA StatiCa

Uploaded by

Omer Mustafa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views4 pages

02 - How To Create A New Project - IDEA StatiCa

Uploaded by

Omer Mustafa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

11/8/24, 12:28 AM 02 | How to create a new project | IDEA StatiCa

ESSENTIALS OF STEEL CONNECTION DESIGN (EN)

02 | HOW TO CREATE A NEW PROJECT


CAMPUS QUIZ

QUIZ SUMMARY
Quiz overall results

Correct answer(s) 2
Incorrect answer(s) 2
Total number of questions 4

Quiz passed successfully

 Quiz results information


The results of the last attempts are provided for the final grade.
In the left part, you can see the quiz results.
You have to achieve at least 50% to pass the quiz successfully.

Finish all quizzes to get certificate

QUIZ QUESTIONS
NAVIGATION

Which image represents the moment connection of a beam to a column?

What is the correct model type setting of a member connected via a single bolt?

https://www.ideastatica.com/campus-quiz/02-how-to-create-a-new-project/result 1/4
11/8/24, 12:28 AM 02 | How to create a new project | IDEA StatiCa

Build the general cross-section according to the attached PDF file. Once the modeling is complete,
write the value of the total area of the cross-section

Is it possible to define a member that is cut at both ends?

1. Question

Which image represents the moment connection of a beam to a column?

https://www.ideastatica.com/campus-quiz/02-how-to-create-a-new-project/result 2/4
11/8/24, 12:28 AM 02 | How to create a new project | IDEA StatiCa

2. Question

What is the correct model type setting of a member connected via a single bolt?
A N-Vy-Mz

B N-Vy-Vz

C N-Vy-Vz-Mx-My-Mz

D N-Vz-My

3. Question

Build the general cross-section according to the attached PDF file. Once the modeling
is complete, write the value of the total area of the cross-section
Tolerance: 60

Answer:

46 mm2

4. Question

Is it possible to define a member that is cut at both ends?


A No. It is not possible.

B Yes. I must define the member using the stiffening member operation.

C Yes. I must define the member as continuous or ended.

D Yes. I must define the member as ended.

https://www.ideastatica.com/campus-quiz/02-how-to-create-a-new-project/result 3/4
11/8/24, 12:28 AM 02 | How to create a new project | IDEA StatiCa

BACK TO ESSENTIALS OF STEEL CONNECTION DESIGN (EN)

https://www.ideastatica.com/campus-quiz/02-how-to-create-a-new-project/result 4/4

You might also like