Scribd
Upload
6 views5 pages

HW5

Uploaded by

Ali Altay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
6 views5 pages

HW5

Uploaded by

Ali Altay
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

CHAPTER 5

HOMEWORK

1) A bipolar transistor is biased in the forward active mode. The collector


current is 𝑖𝐶 = 726𝜇𝐴 and the emitter current is 𝑖𝐸 = 732𝜇𝐴.
Determine 𝛽, 𝛼, 𝑖𝐵
2) An npn transistor with 𝛽 = 80 is connected in a common-base
configuration as shown in Figure. The emitter is driven by a constant-
current source with 𝐼𝐸 = 1.2𝑚𝐴. Determine 𝐼𝐵 , 𝐼𝐶 , 𝛼 and 𝑉𝐶

3) (a)The pnp transistor shown in Figure has a common-base current


gain 𝛼 = 0.9860. Determine the emitter current such that 𝑉𝐶 = −1.2𝑉.
What is the base current?
(a) Using the results of part (a) and assuming 𝐼𝐸𝑂 = 2𝑥10−15 𝐴,
determine 𝑉𝐸𝐵
4) For all the transistors 𝛽 = 75. The results of some measurements are
indicated on the figures. Find the values of the other labeled currents,
voltages, and/or resistor values.

10) Consider the circuit in Figure. The parameters of transistor are 𝐼𝑆 =


5 × 10−16 𝐴 and 𝛽 = 90. Determine 𝑉𝐵𝐵 in circuit such that 𝑉𝐶𝐸 = 1.10𝑉
11) The transistor shown in Figure has 𝛽 = 120. Determine 𝐼𝐶 and 𝑉𝐸𝐶 .
Plot the load line and the Q point.

12) Consider the common base circuit shown in below. Assume the
transistor alpha is 𝛼 = 0.9920. 𝑉𝐸𝐵 (𝑜𝑛) = 0.7𝑉. Determine 𝐼𝐶 , 𝐼𝐸, 𝑉𝐵𝐶
13) The transitor in Figure has 𝛽 = 120. Determine 𝑉𝐼 that produces
𝑉0 = 4𝑉 for (i)𝑅𝐸 = 0 and (ii)𝑅𝐸 = 1𝑘Ω
14) The transistor in the circuit shown in below has a current gain 𝛽 =
𝐼𝐶
40. Determine 𝑅𝐵 such that 𝑉0 = 0.2 and = 20 when 𝑉𝐼 = 5𝑉 (𝑉0 =
𝐼𝐵
𝑉𝐶𝐸 (𝑠𝑎𝑡)). 𝑉𝐵𝐸 (𝑜𝑛) = 0.7𝑉.

15) The current gain for the transistor in the circuit shown in below is
𝐼𝐶
𝛽 = 60. Determine 𝑅𝐵 such that 𝑉0 = 8.8 𝑉 when 𝑉𝐼 = 5𝑉 and = 25
𝐼𝐵
𝑉𝐸𝐵 (𝑜𝑛) = 0.7𝑉

You might also like