Pico W Product Brief
Pico W Product Brief
Raspberry Pi Ltd
Overview
Raspberry Pi Pico W offers 2.4GHz 802.11 b/g/n wireless LAN support and Bluetooth
5.2, with an on-board antenna, and modular compliance certification. It is able to operate
in both station and access-point modes. Full access to network functionality is available
to both C and MicroPython developers.
Raspberry Pi Pico W pairs RP2040 with 2MB of flash memory, and a power supply chip
supporting input voltages from 1.8–5.5V. It provides 26 GPIO pins, three of which can
function as analogue inputs, on 0.1”-pitch through-hole pads with castellated edges.
Raspberry Pi Pico W is available as an individual unit, or in 480-unit reels for automated
assembly.
19.8
2.1
7.3759
WARNINGS
• Any external power supply used with Raspberry Pi Pico W shall comply with relevant regulations and standards
applicable in the country of intended use.
• This product should be operated in a well-ventilated environment, and if used inside a case, the case should not be
covered.
• Whilst in use, this product should be placed on a stable, flat, non-conductive surface, and should not be contacted by
conductive items.
• The connection of incompatible devices to Raspberry Pi Pico W may affect compliance, result in damage to the unit,
and invalidate the warranty.
• All accessories used with this product should comply with relevant standards for the country of use and be marked
accordingly to ensure that safety and performance requirements are met.
• The cables and connectors of all peripherals used with this product must have adequate insulation so that relevant
safety requirements are met.
SAFETY INSTRUCTIONS
To avoid malfunction or damage to this product, please observe the following:
• Do not expose to water or moisture, or place on a conductive surface whilst in operation.
• Do not expose to heat from any source; Raspberry Pi Pico W is designed for reliable operation at normal ambient
temperatures.
• Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.
• Whilst it is powered, avoid handling the printed circuit board, or only handle it by the corners to minimise the risk of
electrostatic discharge damage.