0% found this document useful (0 votes)
36 views8 pages

Manual - RS232 Setting - R00

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
36 views8 pages

Manual - RS232 Setting - R00

Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

SIC LASER ADVANCED

RS232 Setting

SIC Marking
13, Route de Limonest
ZAC de la Braille
69380 Lissieu
France
Telephone: +33 (0)4.72.54.80.00
Fax: +33(0)4.78.47.39.40
E-Mail: [email protected]
http://www.sic-marking.com

Manual -RS232 Setting - R00.docx 1/8


TABLE OF CONTENTS
1 HOW TO CHANGE THE RS232 PARAMETERS ............................................................................................. 5

Manual -RS232 Setting - R00.docx 3/8


Manual -RS232 Setting - R00.docx 4/8
1 HOW TO CHANGE THE RS232 PARAMETERS

 Connect the PC to the laser rack with a USB cable


 Kill the process “sc_usc_server.exe”
o Press “CRTL + Alt + DEL” to open task manager
o Kill the process “sc_usc_server.exe”

 Open on visible mode the “sc_usc_server.exe” on visible mode

Manual -RS232 Setting - R00.docx 5/8


o Select “run”

o Find the sc_usc_server.exe (c:\sic_marking\laser\system\)

Manual -RS232 Setting - R00.docx 6/8


o Add –v parameter at the end to lunch the exe in visible mode

o On the USC SERVER window, press FLASH button

o Press PC MODE BUTTON

Manual -RS232 Setting - R00.docx 7/8


o SET YOUR COMMAND : SBR 9600 (for example)

o PRESS OK BUTTON
o EXIT sc_usc_server.exe
o Unplug the USB cable
o Press “RESET” button on the front of the rack
o System is ready to work again in stand alone mode with the new parameters

Manual -RS232 Setting - R00.docx 8/8

You might also like