Scribd
Upload
13 views1 page

Key Programming

Uploaded by

ruizpedro5515
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
13 views1 page

Key Programming

Uploaded by

ruizpedro5515
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2004-2006 Pontiac GTO

Key programming

Key FOB Transmitter Programming

You can't program the remote without being able to put it in the ignition and turn it to the
different positions. Have the key cut by a locksmith and use the procedures below to
program the remote. A locksmith that has the capability/equipment to cut center cut keys
can do it.

Transmitter Programming
The transmitter may not communicate with the receiver if any of the following situations
occurs:

- The transmitter battery wears down.


- The transmitter key has been replaced.
- The Body Control Module (BCM) has been replaced.
Perform the synchronizing procedure if the transmitter does not communicate with the
receiver. If the transmitter and/or receiver are replaced, preform the following programming
procedure:

Programming Transmitters Without Tech 2


- Turn the ignition to ON, then wait 10 minutes for the next step in the programming
sequence.
- After the 10 minutes has elapsed, the car horn will chirp once. Turn the ignition switch to
the OFF position within 5 minutes after the horn has sounded, then to the ON position
within 5 seconds after switching it OFF.
- Leave the key to the ON position for 10 minutes. After the 10 minutes has elapsed, the car
horn will chirp twice. Turn the ignition switch to the OFF position within 5 minutes after the
horn has sounded, then to the ON position within 5 seconds after switching it OFF.
- Leave the key to the ON position for 10 minutes. After the 10 minutes has elapsed, the car
horn will chirp 3 times.
- Verify that the security indicator in the instrument cluster has stopped flashing and
attempt to start the vehicle.
- Turn the ignition to OFF and remove the key from the ignition switch.
- Move approximately 3 meters (10 ft) away from the vehicle and test the transmitter
functions to validate that the transmitter has been programmed successfully.

You might also like