Single answer Questions

1. Agas fiow with a velocity V along a pipe of cross sectional area s and bent at an angle of 90 at a point A. What
force does the gas exert on the pipe at A. If its density is p ?
(A)2s (B)V2sv'p (C).Vãsv'p
22
(D) \3sV'p
 Awedge of
mass M and
figure is. lying dimensions as shown in the
pressure. The completely inside a
pressure inside regionregion () of zero
|l is 1 Pa. Region -I
surface are smooth. The wedge is The
velocity V, so imparted an
that it just travels a initial h

region il before finallycoming to distance b inside Region - II

is rest. The value of v

abh
(8)4V M

(C)ahh |4 abh

3. Asmnall block B is supported by a

platform connected at A to rod OA. Point A
describes a circle in avertical plane at a
constant speed v,. The coefficient
of friction between the block and the 4

platform are 4,=F and 4 = 1

The maximum speed v,,for the block not to slide on the
platform is 400 mm

(A) 6 m/s (B) 5 m/s

(C) 2 m/s (D) none of these

4. A block is placed on arough horizontal plane (xz - plane) with

coefficient of
friction is equal to u. In Yand Z direction constant force mg is applied as mg

shown, and in the X - direction a time varying force F = mgt is applied, F = mgt
where t is time. If block starts moving at time t= 1s. Then value of u is
E= mg (m = mass of block, X -Z

(B) rough horizontal surface)

1
(D)
3

5 Two blocks A and B of masses m, =2 kg and

) =10 rad/s
m, =4 kg respectively are connected by an
ideal string of length = 0.5 mand placed
along the diameter of a rough horizontal
circular disc at distance l, =0.3 mand
A
l, =0.2 mrespectively from the centre '0' as
shown. The disc is rotated with a constant m, m,
angular velocity ) =10 rad/s about its vertical
axis passing through the centre 0. The H, =0.5
H, =0.6
coefficient of friction between the disc and the
blocks A and B are , =0.5 and , =0.6
respectively. The frictional force acting on the
block 'A' is (take g= 10 m/s')
(A) 2 N (B 4 N
(C) 6 N (D) 8 N
 6 SCO
Smooth, idenical logs are piled in astake truck. The truck is
forced off the highway and comes to rest on an even keel
lengthwise
as shown in
but with the bed at an angie 0with the horizontal.
the log Figure. As the truck is unioaded, tne removal of
shown dotted leaves the remaining threeina condition
where they are (ust ready to síide, that is,if were any smaller,
the logs would fall
down. Find 0
(A) -tan

(B) tan 1

(C) tan

(D) 0-tan
53

1 MCO
One or more than questions
The rotaion of rod OA ebout 0 is
defined by the relation
e=4 -81), wihere and t are expressed in radians and
seconds, respectively. Collar B slides along the rod so that its
distance from O is r 10 + 6 sinrt, where r andt are
metres and seconds, respectively. When t=1 s. expressed in

(A The speed of the coliar in radial

direction is 6z mis.
(B) The speed of the coliar in tangentiai direction is 80r m/s
(C) The speed of the collar in radiai direcion is zero.

() The speed of the coilar in tangenial direcion is zero.

2 MCO A untform massive string of mass m, length is fixed between two

rigid supports. Angles made by the tangents on the string at points
of suspension are shown in the figure. The point C is the iower most
point of the string. Then choose the correct option(s). 37
16:
(A) Length of string left of the point C is
25
(B) Tension in the siring at point C is
12mg
5
12
(C) Radius of curvature of the siing at point C is
25
(D) Tension in the string at point B is Smg
5

3 MCO An Atwood's machine having infinite number of masses connected with

idealstrings as shown in the fiqure. All the masses are ldentical and equal
to m. Allthe pulleys are ideal. Then choose the correct option(s).
(A) Acceleration of mass-1 is g/2
(B) Ratio of acceleration of mass-1 and mass-2 is 2
Totalwork done by tension is zero
(D) Acceleration of mass-1 can't be determined 2
m
 MCO
Aparicie of
angle a with weight
the
Wrests on a
rough incined
staic riction u 2 tan o) Aas shown in Fiqure plene
horizontal, thal
Mthe makes an
plane (see fore ) force His acting coefficlent to
the sBope of fhe horizontal of
transverse

(A H 23 W
sin the particle will move on the inctine plane
(B WH05W sin the particle will move on the
incline pBane
(C) HHJ3 Wsin a the cireeion &in which the block
goes, relative to His 30
(D) HH0.5W sin a the direction in which the block goes, relative to H
is 60

MCO A unifom circular ring of mass m 5 kg andradius

R=30 om is hinged at the point 'A' of a siationary m, R
Surfaoe with the ine joining point 'A' to the centre 'C'
of the ring is initialiy vertical. The ring is also in
oontact with the Piank of mass m=5 kg at point 'B
which is piaced on a smooth horizontai surface. B
initialty points 'A' and B' are almost touching and
the line AC is vertical and the system is released
from rest. Then the velocity of the Plank when the
line AC makes an angle 30° with the horizoniai as
shown wil be (tihere is no friction between ihe ring
and the piank and g= 10 m/s")
A) 1 m/s
(B) 2 mis
(C) 3 m/s
(D) 4 m/s

6 MCO
A biock'A of mass 4m is piaced on the block Bof same mass
4m which is placed on a rough horizontal surface with
coeficient of fricüon uz * 0.2. The coeficient of friction between 37
the biocks is us = 0.4. A bail of mass m moving witha veiocity
Vp = 10 m/s collides with the bicck 'A' at an angie = 37° with
the nomal to the suriace as shown and gets stuck to it. Then
choose the correct option(s). 4m A
H=0.4
#2=0.2 4m B

(A The velocity of biock 'A' just after colision is 0.56 m/s.

(B The veiocity of biock 'A' just after collision is 0.28 mfs.
(C The velocity of bBock 'B' just after colision is 0.40 m/s.
(D The velocity of block B' just after colision is 0.20 m/s.

Numerical Questions
N1. One end of the pile of chain falls vertically through a hole in its
Support and
pul the remaining links steadily. The links which are at rest acquire
the

velocity of the hanging position suddenly and without having

interaction with
the remaining stationary links and with the support. If the
acceleration a of
the falling chain is g/k. Find k. lgnore any
friction.
 N2. Adlsc'A of mass Mis placed at rest on the smooth incline surface of
inclination . Aball of Bof mass m is suspended vertically from
the centre of the disc A bya liaht inextensible string of length as
shown in the figure. If the acceleration of the disc Bimmediately
(M+ km)gsin 0
after the system is released from rest is M+msin 0 Find k.
N3. Adroptet of water in uniform fog is formed, then falls sweeping up the fog yng ts P
Assume that it retains al the fog fn #s patin, remains sphericai and experlences zero drag. Drop
atans a constani value of acceleration after a large time interval. its acceleration is given by K
Find the value of K

N4 Three ictenicai snooth spheres each of mass m

ko on a smooth horizontal ptane are in contact
with one another, and are kept together by an endless
string in the plane of their centers, just fitting them: \THREAD
when a fourth identicai sphere is placed on them, the
tension in the string is newton, then find the value
of k. (Take g= 10m/s).

TOP VIEW

N5
An old record player of 10 cm radius turns at 10 radis while mounted
on a 30° incine as shown in the figure. A particde of mass m can be
placed anywhere on the rotating record. f the least possibie
coefficient of fricion that must exist for no slipping to occur is u,
find 2434 . (Take g=10 m/s) b
30°/
N6 Acylinder and a wedge with a vertical face touching each
other, move along two simooth inciíned planes making the
same angie t = 45° with the horizontal as shown in the
figure. The masses of the cylinder and the wedge are m=
5 kg and m = 3 kg respecively. There is no friction
between the cylinder and the wedge. Find the normal force 9s45 A045
(in Newton) acting between the cylinder and the wedge.
(Take g = 10 m/s)

N7 The coliar of mass m slides up a verical shaft under the action of a force
F of constant magnitude but variable direction. lf the angle made by the
force F with the vertical at any time t is = kt where k is a positive
constant and collar starts from = 0. The collar comes to rest as 0
reaches the value ni2. The coefficient of kinetic friction between the
collar and shaft is u, = 1/3. If the value of F= nnmg, then find the value
of n.
o.15

N8
Radius of cylinder A and B are same and equal to 4R
while the radius of cylinder C ls R. Ai hree cylinders are
released trom rest. Magnitude of acceleralion of cylinder A
ls aj and that of cylinder C Is a). IH the ratio of ! s

hen find the value of k. (ali the surfaces are frictionless) h

*******k*******SPACE FOR ROUGH****************