Scribd
Upload
11 views

arduino nano

hi

Uploaded by

HamedRaza
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
11 views

arduino nano

hi

Uploaded by

HamedRaza
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Arduino Pro Mini

Image:

The Arduino Pro Mini is an ATmega168 based microcontroller board. The board
comes with built-in arduino bootloader. It has 14 digital input/output pins (of which 6 can
be used as PWM outputs), 8 analog inputs, an on-board resonator, a reset button, and
holes for mounting pin headers. The board can be connected to the PC using USB port
and the board can runs on USB power.
There are two version of the Pro Mini. One runs at 3.3V and 8 MHz, the other at 5V and
16 MHz.
Arduino Pro Mini DETAILS

Microcontroller ATmega168
Operating Voltage 3.3V or 5V
3.35 -12 V (3.3V model) or 5 - 12 V (5V
Input Voltage
model)
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 8
DC Current per I/O Pin 40 mA
Flash Memory 16 KB (of which 2 KB used by bootloader)
SRAM 1 KB
EEPROM 512 bytes
Clock Speed 8 MHz (3.3V model) or 16 MHz (5V model)

Arduino Pro Mini PINOUT


For supplying a raw (regulated) voltage to
RAW
the board
VCC The regulated 3.3 or 5 volt supply
GND Ground pins
RX Used to receive TTL serial data
TX Used to transmit TTL serial data
Digital I/O pins. These pins can also be
configured to trigger an interrupt on a low
2 and 3
value, a rising or falling edge, or a change
in value
Digital I/O pins. They can also be
3, 5, 6, 9, 10, and 11
configured to provide 8-bit PWM output
Digital I/O pins. They can also be
configured as SPI pins;
10, 11, 12 and 13
10 - (SS), 11 - (MOSI), 12 - (MISO) and 13
- (SCK)
A0 to A3 Analog input pins
Analog input pins. They can also be used
A4 and A5. as IIC pins;
A4 - (SDA) and A5 – (SCL).
A6 and A7 Analog input pins
The microcontroller can be reset by
Reset
bringing this pin low

You might also like