Scribd
Upload
15 views5 pages

GT-How To Add Your Design Via Photoshop

Uploaded by

Ines Varela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
15 views5 pages

GT-How To Add Your Design Via Photoshop

Uploaded by

Ines Varela
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

HOW TO ADD YOUR DESIGN via Photoshop

1. Open your Photoshop file and double click on the smart object icon with the name "Your Design
Here".

2. This box would pop up and click OK.


3. It will lead you to smart object layer (psb file) in the new window.

4. Add your own design. It can be from any file in which you have created your design (pdf file, png/jpeg
image, Illustrator, etc).
PS: You can check the other PDF file "How to transfer your design from Adobe Illustrator to Adobe
Photoshop" if you are not familiar on how to do it.

Start adjusting the size and position of your design. Make sure that it is within the white object and
SAVE (Ctrl+S).

Here is how to adjust your design:


1. Click the chain icon (to make sure proportion of the design is balanced when being adjusted)
2. Move your mouse until you see either of these icons:
- to adjust the position of your design (move within selected design)

- to resize your design (move to any one of the 4 corners of selected design)

Any one of the above icons to rotate your design (move around selected design)
3. Enter
4. Save (Ctrl+S)

Should you wish to resize only the length or the width of your design, you do not need to click the
chain icon. Simply move your mouse to the dot at the top / bottom / left /right of selected design
until you see either of these 2 icons :
- to adjust the width of your design

- to adjust the length of your design


Do not worry about the side shape, paper hole and string if your design is an image / drawing /
picture that covered the tag. You only need to adjust the height and width (as shown in the right
picture below) of your design to fit the mockup image nicely. After you are done, SAVE (Ctrl+S) and
close the window. Those side shape will be cut accordingly when you go back to the main psd file.
5. If you are not happy with the result, you can re-adjust again by repeating this step:
a. Click the chain icon
b. Ctrl+T to select and adjust the size / position and start moving your mouse until you see one of
those icons as explained in step 4.
c. Enter
d. Save (Ctrl+S)

6. When you are done, close the window. It will go back to your main psd file.

7. Back to the main psd file and the image is now ready with your design.

8. Anytime you want to change/adjust your design, simply repeat step 1 - 7.

You might also like