Scribd Logo
Upload

Welcome to Scribd!

  • 1 views

    User Guide FX and FS English rev.22.07.24

    Uploaded by

    djrqgnft2x

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    User Guide FX and FS English rev.22.07.24

    Uploaded by

    djrqgnft2x
    1 views5 pages

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    1 views5 pages

    User Guide FX and FS English rev.22.07.24

    Uploaded by

    djrqgnft2x

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 5

    User Guide

    We maintain controls of:


    Congratulations on achieving the
    Individual volume
    highest technology of accordion Bass tone
    microphones! Mono/stereo output

    New features:
    Variable tremolo effect for the right hand,
    Octaver for bass (sub bass)
    Feedback Suppressor - FS
    Tremolo - FX

    There are two tremolo controls: On/Off via the FX


    button and intensity adjustment on the potentiometer,
    ranging from dry to musette.

    Click and Learn More

    Mono/stereo change

    To switch between mono and stereo output, you need to press


    the FS and Octaver buttons at the same time. You will hear a
    tone to confirm the change. The output configuration will then
    be stored in the microphone.

    Click and Learn More

    Octaver

    The bass sub-octave is activated via the


    tone control button. Its intensity can be
    adjusted using the tone control
    potentiometer.

    Click and Learn More


    Octaver Configuration

    To ensure optimal performance of the Octaver, you must


    configure the lowest note of the basses.

    Press the FX, FS and Octave buttons simultaneously to change


    the configuration:

    Setting 1: A - Factory default


    Setting 2: C
    Setting 3: G
    Setting 4: E

    When you change the setting, you will hear a tone corresponding
    to the configured note.

    P R E SS

    TOGETHER
    Feedback Suppressor - FS

    The FS (Feedback Suppressor) function works with a simple


    click on the bass volume button during feedback, as the
    microphone must "listen" to the remaining frequency to
    eliminate it.
    Furthermore, to achieve the best effectiveness, the FS is
    used separately for bass and vocals. Therefore, to eliminate
    treble feedback, you should adjust the bass volume to zero,
    and to cancel bass feedback, adjust the treble volume to
    zero.

    IMPORTANT: Disable the vibrato and octaver effects


    during the feedback cancellation process.

    The microphone eliminates up to 10 frequencies for the right


    hand and 5 for the left. These settings remain stored even
    after disconnecting the cable.
    When the suppression is done, you will hear 1 beep after the
    click.
    If the microphone emits 2 beeps it means that the frequency
    limit has been reached or it has not been identified.
    To reset the FS press and hold the FS button until you hear 3
    beeps (about 5 seconds)

    Click and Learn More

    You might also like