330C L & 330C LN Excavators CAP00001-UP (MACHINE) POWERED BY C-9 En...
Page 1 of 3
Cerrar SIS
Pantalla anterior
Producto: EXCAVATOR Modelo: 330C L EXCAVATOR CAP01103 Configuración: 330C L & 330C LN Excavators CAP00001-UP (MACHINE) POWERED BY C-9 Engine
Desarmado y Armado C9 Engine For Caterpillar Built Machines Número de medio -SENR9502-16 Fecha de publicación -01/03/2014 Fecha de actualización -06/03/2014
i07638894
Unit Injector Sleeve - Remove
SMCS - 1713-011
Removal Procedure Table 1 Required Tools Tool Part Number Part Description Qty A 1P-3042 Plug Tap 1 B 221-0052 Guide Sleeve 1 9U-6858 Bridge Plate 1 1B-2886 Bolts 2 221-9778 Puller Stud 1 C 4K-0367 Full Nut 1 5P-8247 Hard Washer 1 9U-6877 Thrust Bearing 1 D 221-9803 Rubber Stopper 1 E 151-4832 Injector Sleeve Tool(1) 1 (1) Alternative tooling
Start By:
a. Remove the unit injectors. Refer to Disassembly and Assembly, "Unit Injector - Remove".
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/siswe... 7/1/2025 330C L & 330C LN Excavators CAP00001-UP (MACHINE) POWERED BY C-9 En... Page 2 of 3
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
NOTICE
Care must be taken to ensure that fluids are contained during
performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.
Refer to Special Publication, PERJ1017, "Dealer Service Tool
Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.
Dispose of all fluids according to local regulations and mandates.
1. Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".
2. Position Tooling (D) at the bottom of the unit injector sleeve.
3. Coat Tooling (A) with clean grease. Use Tooling (A) and Tooling (B) to cut threads into the unit injector sleeve.
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/siswe... 7/1/2025 330C L & 330C LN Excavators CAP00001-UP (MACHINE) POWERED BY C-9 En... Page 3 of 3
Illustration 1 g01137445
4. Install Tooling (C) in unit injector sleeve (1).
5. Remove unit injector sleeve (1). Remove the O-ring seals.
Copyright 1993 - 2025 Caterpillar Inc. Tue Jan 7 14:41:37 EST 2025 Todos los derechos reservados. Red privada para licenciados del SIS.
