SBISO
SBISO
VIGO OIL SB150 is based on synthetic hydrocarbon oil and refined mineral oil, and contains
organic molybdenum. This reduction gear oil can efficiently cover intricate gear parts in need of lubrication,
which increases gear efficiency and extends lubrication life.
Typical Properties
VIGO OIL
Test item Test method
SB150
●The above values are typical properties and we cannot guarantee the applicability of this information in any individual situation.
●Material Safety Data Sheet (MSDS) of the product should be consulted prior to the use.
●The information contained herein is subject to change without notice.
●Nabtesco,VIGOOIL is a registered trademark of Nabtesco Corporation.
http://www.nabtesco.com
W32030016
PAGE 1
HAZARDOUS INGREDIENTS
NAME CAS No. CONTENTS (%)
HAZARDOUS IDENTIFICATION
ADVERSE HUMAN HEALTH EFFECTS : Prolonged and repeated contact may cause skin
irritation.
ENVIRONMENTAL EFFECTS : No data available
W32030016
PAGE 2
EYES : Immediately flush with water for at least 15 minutes. Get medical attention.
SKIN : Remove excess with cloth or paper and wash area thoroughly with soap and water.
INHALATION : Keep the victim warm and quiet. Remove the victim from the contamination
Immediately to fresh air.
FLAMMABLE PROPERTIES :
FLASH POINT : 234 METHOD : COC Method
FLAMMABLE LIMITS : LFL : N/A UFL :N/A
AUTOIGNITION TEMPERATURE : no data available
HAZARDOUS DECOMPOSITION PRODUCTS : Thermal decomposition and combustion may
produce carbon monoxide and/or carbon dioxide.
FIRE FIGHTING INSTRUCTIONS : Dense smoke. Fire fighter wear an approved self-contained
breathing apparatus. Do not use water except fog.
PROCEDURE FOR CLEAN-UP : Shut off all sources of ignition. Prevent spills from entering sewers
water courses or low area. For large spills, dike for later disposal. For small spills,
absorb spill with inert materials(e.g., dry sand or earth), then place in a chemical waste
container with covers for disposal, using non-sparking tools.
Do not wash away in to shower or waterway.
WASTE DISPOSAL : Dispose of in accordance with all applicable federal, state and local
regulations..
HANDLING : Contact with eyes may cause irritation. Use protective glasses and other devices to
avoid contact with eyes.
Contact with skin may cause irritation. Use protective glove to avoid contact with skin
contact.
Inhalation of oil mist or fume may cause irritation. Use protective mask or other devices
to avoid inhalation.
Do not swallow. (Drinking product cause diarrhea and vomiting.)
Keep out reach of children.
STORAGE : Keep container closed until ready for use. Storage away from fire source or sunlight
and in cool dry area.
W32030016
PAGE 3
CONTROL PARAMETERS :
Oil mist, mineral: ACGIH TLV (2007): TWA 5mg/m3
EYE PROTECTION : Chemical safety goggles and if handled hot, full face shield.
HAND AND BODY PROTECTION : Protective gloves, rubber or plastic oil resistant.
STABILITY : (CONDITION TO AVOID) Product is stable under normal condition. Avoid over
heating.
INCOMPATIBILITY : ( SPECIFIC MATERIALS TO AVOID) Strong oxidizers such as hydrogen
peroxide, bromine, and chromic acid.
HAZARDOUS DECOMPOSITION PRODUCTS : sulfur, phosphorus, molybdenum, calcium,
nitrogen.
HAZARDOUS POLYMERIZATION : none
REACTIVTY WITH WATER : none
TOXICOLOGICAL INFORMATION
PAGE 4
DISPOSAL CONSIDERATION
ATTENTION : Do not use pressure to empty this container. When empty, container may have vapor
or product residue. Do not cut, puncture or weld on near the drum.
TRANSPORT INFORMATION
REGULATORY INFORMATION
Regulatory information with regard to this product in your country or your region should
be examined by your own responsibility.
PAGE 5
This MSDS is an addition and complementary document beside the technical data sheet.
The information is based upon our knowledge about the product at the date of edition.
Since we cannot anticipate or control the different conditions under which these information
or our product may be used, we make no guarantee that recommendations will be adequate for all
individuals and situations.