Scribd
Upload
45 views2 pages

Mixed Quiz 4

Uploaded by

1502a
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
45 views2 pages

Mixed Quiz 4

Uploaded by

1502a
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

1 CORRECT Which encoding technique attempts to solve the loss of synchronization due to long strings of 0s?

A)NRZ
B)BnZS
C)AMI
D)(a) and (b)

2 CORRECT Block coding can help in _______ at the receiver.


A)Synchronization
B)Error detection
C)Attenuation
D)(a) and (b)

3 CORRECT In _______ transmission, bits are transmitted simultaneously, each across its own wire.

A)Parallel
B)Asynchronous serial
C)Synchronous serial
D)(a) and (b)

4 CORRECT Unipolar, bipolar, and polar encoding are types of _______ encoding.
A)Block
B)Line
C)NRZ
D)Manchester

5 CORRECT _______ encoding has a transition at the middle of each bit.


A)RZ
B)Manchester
C)Differential Manchester
D)All the above

6 CORRECT _______ encoding has a transition at the beginning of each 0 bit.


A)Differential Manchester
B)RZ
C)Manchester
D)All the above

7 CORRECT PCM is an example of _______ conversion.

A)Analog-to-analog
B)Analog-to-digital
C)Digital-to-digital
D)Digital-to-analog

If the frequency spectrum of a signal has a bandwidth of 500 Hz with the highest frequency at 600 Hz, what should be the sampling
8 CORRECT
rate, according to the Nyquist theorem?
A)500 samples/s
B)1000 samples/s
C)200 samples/s
D)1200 samples/s

9 CORRECT One factor in the accuracy of a reconstructed PCM signal is the _______.

A)Number of bits used for quantization


B)Signal bandwidth
C)Carrier frequency
D)Baud rate

10 CORRECT In asynchronous transmission, the gap time between bytes is _______.

A)Fixed
B)A function of the data rate
C)Variable
D)Zero

11 CORRECT Synchronous transmission does not have _______.


A)A start bit
B)A stop bit
C)Gaps between bytes
D)All the above

12 CORRECT Which encoding type always has a nonzero average amplitude?


A)Polar
B)Bipolar
C)Unipolar
D)All the above

13 CORRECT Which of the following encoding methods does not provide for synchronization?

A)Manchester
B)NRZ-L
C)RZ
D)NRZ-I

14 CORRECT Which encoding method uses alternating positive and negative values for 1s?

A)Manchester
B)AMI
C)NRZ-I
D)RZ

15 CORRECT In PCM, an analog-to- _______ conversion occurs.


A)Analog
B)Digital
C)QAM
D)Differential

16 CORRECT If the maximum value of a PCM signal is 31 and the minimum value is -31, how many bits were used for coding?

A)4
B)5
C)6
D)7

17 CORRECT RZ encoding involves _______ signal levels.


A)Five
B)Four
C)Three
D)Two

18 CORRECT Which quantization level results in a more faithful reproduction of the signal?

A)2
B)8
C)16
D)32

19 CORRECT In _______ transmission, bits are transmitted over a single wire, one at a time.

A)Asynchronous serial
B)Synchronous serial
C)Parallel
D)(a) and (b)

20 CORRECT In _______ transmission, a start bit and a stop bit frame a character byte.

A)Synchronous serial
B)Asynchronous serial
C)Parallel
D)(a) and (b)

21 CORRECT If a symbol is composed of 3 bits, there are _______ data levels.

A)2
B)4
C)8
D)16

22 CORRECT The Nyquist theorem specifies the minimum sampling rate to be_______.

A)Twice the bandwidth of a signal


B)Twice the highest frequency of a signal
C)Equal to the lowest frequency of a signal
D)Equal to the highest frequency of a signal

23 CORRECT Pulse rate is always _______ the bit rate.

A)Less than
B)Less than or equal to
C)Greater than
D)Greater than or equal to

You might also like