0% found this document useful (0 votes)
13 views3 pages

2023-Control System Apr-May (AICTE)

Dddf

Uploaded by

5z9tvj6g5q
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
13 views3 pages

2023-Control System Apr-May (AICTE)

Dddf

Uploaded by

5z9tvj6g5q
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

NPUR

Me
MSTITUTE
EOF
49030N
Printed Pages 4 Roll No.
LIBRARY
TECH
RAIPUR (C.G.

C028514(028)
B.Tech. (Fifth Semester) Examination
April-May 2023
(New Scheme)
(ET & T Engg. Branch)
CONTROL SYSTEM
Time Allowed : Three hours

Maximum Marks : 100

Minimum Pass Marks : 35

Note : Atempt all questions. Part (a) is compulsory.


Atempt any two out of part (b), (c) or (d) in
each questions.

1. (a) Give the application ofAutomatic Control System? 4


(b) Discuss Block Diagram Representation Techniques
indetail.

CO28514(028) PTO
|2 | |3|

(c) Expiain the difterences between Open loop and derivative feedback control.
closed loop and closedloop control system with (d) Explain time response of second order control
exaniple 8 System.

(d) Obtain the closed loop transfer function for the


3. (a) Write Routh-Hurwitz stability criterion. 4
system show in figure 8
(b) Using Routh's criterion, check the stability of the
system
2s* + s +2s* +s+20=0

(c) For the open loop transfer function given below.


Determine the value of breakaway points and
comment as the stability and time response of the
2. (a) What is steady state error? 4 system.

(b) Discuss feedback characteristics of control system


in detail. G(s).H(s)=
s(s+4)(s°+4s +13)
(c) The overall transfer function of acontrol system is
given by (d) Describethe performance analysis of control system
using Root loci.
16
R{s) l6+1-6s + 4. (a) What is Phase Margin? 4

It isdesired that dampling ratio be 08. Determine (b) Draw Polar plot for given system
the derivative rate feedback constant K, and compare
10
ise time, Peak tine, Maximum overshoot and steady G(s).H(s) =
state error for unit ramp input without and with
s(s+1)|s+2)
CO28514(028) C028514(028)
|4
on its
Calculate its gain margin in dB. Comment
stability.
transfer
(c) Sketch the asyniptotic Bode plot forthe
function given below:
K
G{s) H(6}= ss+2)(s+10)
Calculate :
Gain and phase cross over frequency
Gain and phase Margin
(d) Describe Al-Pas, Minimum and non-niniunum phase
8
system with exaple.

5. (a) What is Diagonalization? 4

(b) Verify the controllability. Given that 8

i, =-2x,-3x, +u +I
(c) Explain Nyquist stability Criteria in detail.
(d) Explain the concepts of controllability and
observability.

210) C028514(028)

You might also like