Scribd
Upload
11 views2 pages

Sheet2 2024 Part 1

Uploaded by

Muhamed Elsayed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views2 pages

Sheet2 2024 Part 1

Uploaded by

Muhamed Elsayed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Benha University 4rd year

Faculty of Engineering (Shoubra) 1st Semester, 2024-2025


Electrical Engineering Department Power Electronics 2

Assignment 2: DC- DC Voltage Regulators


Buck DC – DC Converters
1.The buck converter of Figure 1 has the following parameters: supply voltage (V s) =
24.0 V, duty ratio (D) = 0.65, L = 250.0 μH, C = 75.0 μF, and R = 10.0 Ω.
The switching frequency is 25.0 kHz. Determine:
a. the average output voltage,
b. the maximum and minimum inductor current, and
c. the output voltage ripple.
d. The average and rms switches currents.

Figure 1: Buck converter

2. The buck converter of Fig. 2 has an input of 50 V and an output of 25 V. The


switching frequency is 100 kHz, and the output power to a load resistor is 125 W
Determine:
a. the duty ratio.
b. the value of inductance to limit the peak inductor current to 6.25 A.
c. the value of capacitance to limit the output voltage ripple to
0.5 percent.
d. The average and rms inductor and capacitor currents
Boost DC – DC Converters
3. The boost converter of Figure 2 has the following parameters: Vs = 20 V, D = 0.6, L =
65.0 μH, C = 200.0 μF, and R = 12.5Ω, and switching frequency = 40.0 kHz.
Determine:
a. the average output voltage,
b. the average, maximum, and minimum inductor currents,
c. the output voltage ripple, and
d. the average current in the diode.

1|P a g e
Figure 2: boost converter

4. Design a boost converter to provide an output of 18 V from a 12-V source. The load is
20 W. The output voltage ripple must be less than 0.5 percent. Specify the duty ratio,
the switching frequency, the inductor size and rms current rating, and the capacitor
size and rms current rating. Design for continuous current. Assume ideal components.

Buck-Boost DC – DC Converters
5. The buck-boost converter of Figure 3 has the following parameters: Vs = 12 V, D=
0.6, L = 50μH, C = 200μF, and R = 10Ω, and switching frequency = 40kHz.
Determine:
a. the output voltage,
b. the average, maximum, and minimum inductor currents, and
c. the output voltage ripple.

Figure 3: Buck-boost converter

6. Design a dc-dc converter to produce a -15V output from a source that varies from 12
to 18 V. The load is a 15 Ω resistor.
Ću k DC – DC Converters
7. Draw power circuit diagram of cuk converter and explain principles of operation

2|P a g e

You might also like