0% found this document useful (0 votes)
6 views5 pages

Week 7 July22

Uploaded by

suganeshz555
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
6 views5 pages

Week 7 July22

Uploaded by

suganeshz555
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

1. LPWAN enables long range wireless communication among “things” ata _____________.

(a) Low bit rate


(b) High bit rate
(c) Customized bit rate
(d) None of the above

Answer: (a)
Justification: Refer to slide 3 of lecture 1 from week 7

2. “LoRa defines only the physical layer of the OSI stack, LoRaWAN handles the networking
aspects of communication.” True or false?
(a) True
(b) False

Answer: (a)
Justification: Please refer to Page 227 of Chapter 10 of the book Introduction to Industrial
Internet of Things and Industry 4.0.

3. The SIGFOX radio link operates in the _____________.


(a) Unlicensed ISM radiobands
(b) Licensed ISM radiobands
(c) Both (a) and (b)
(d) None of the above

Answer: (a)
Justification: Refer to slide 5 of lecture 1 from week 7

4. Xbee is a _____________.
(a) Mesh communication protocol based on the IEEE802.15.4
(b) Product that uses the Zigbee communicationprotocol for radio communication.
(c) All of the above
(d) None of the above
Answer: (b)
Justification: Refer to slide 7 of lecture 2 from week 7

5. Which of the following is/are true about ZigBee?


(a) Zigbee is a communication protocol with its physical layer-based on the IEEE
802.15.4.
(b) Supports 4 topologies: Bus, Star, Tree and Mesh
(c) Used in home and industrial automation applications
(d) All of the above

Answer: (c)
Justification: Refer to slide 5 of lecture 2 from week 7

6. In Zigbee, end devices _____________.


(a) Acts as a bridgebetween different networks.
(b) Relays the information to other nodes in the network
(c) Responsible to connect to the parent node, norelaying of information is supported.
(d) None of the above

Answer: (c)
Justification: Refer to slide 6 of lecture 2 from week 7.

7. The main components of Distributed Control Systems (DCS) _____________.


(a) Central supervisory controller
(b) Distributed controllers
(c) Field devices such as sensors and actuators
(d) All of the above

Answer: (d)
Justification: Refer to slide 7 of lecture 5 from week 7
8. Which of the following is/are type(s) of Industrial Control Systems?
(a) Programmable Logic Controllers (PLCs)
(b) Distributed Control Systems (DCS)
(c) Supervisory control and Data Acquisition (SCADA)
(d) All of the above

Answer: (d)
Justification: Refer to slide 5 of lecture 5 from week 7

9. Which one is correct Pin configuration of a DHT sensor?


(a) PIN 1- 3.3V-5V Power supply, PIN 2- Data, PIN 3- Null and PIN 4- Ground
(b) PIN 1- Data, PIN 2- 3.3V-5V Power supply, PIN 3- Null and PIN 4- Ground
(c) PIN 1- Data, PIN 2- Null, PIN 3- 3.3V-5V Power supply and PIN 4- Ground
(d) PIN 1- Ground, PIN 2- Data, PIN 3- Null and PIN 4- 3.3V-5V Power supply

Answer: (a)
Justification: Refer to slide 11 of lecture 1 from week 7

10. Which one is the correct NodeMCU – DHT interfacing?


(a) GPIO 4 – Data, 3V3 – Vcc, and Gnd – Gnd
(b) GPIO 4 – Gnd, 3V3 – Vcc, and Gnd – Data
(c) GPIO 4 – Vcc, 3V3 – Data, and Gnd – Gnd
(d) None of the above

Answer: (a)
Justification: Refer to slide 13 of lecture 1 from week 7
11. What does iRobot-Factory enforce to improve its manufacturing process?
(a) Cognitive intelligence
(b) Managerial intelligence
(c) Logistic intelligence
(d) All of the above

Answer: (a)
Justification: Refer to slide 14 of lecture 4 from week 7

12. The architectural layers of SmartSantander include __________.


(a) Accessible, Authorization, and Accounting subsystem
(b) Authentication, Authorization, and Accounting subsystem
(c) Authentication, Authorization, and Accommodation subsystem
(d) None of the above

Answer: (b)
Justification: Refer to slide 12 of lecture 4 from week 7

13. Rule-based engine of IIoT processing _____________.


(a) Extract causal and temporal patterns using predefined rules
(b) Handles multiple data streamsand correlates them to providemeaningful output
(c) Both (a) and (b)
(d) None of the above

Answer: (c)
Justification: Refer to slide 5 of lecture 3 from week 7

14. Software layer between infrastructure layer and applicationlayer _____________.


(a) Provides services according to device functionality
(b) Support for heterogeneity, security
(c) Both (a) and (b)
(d) None of the above
Answer: (c)
Justification: Refer to slide 7 of lecture 3 from week 7

15. A typical industrial control system includes _____________ types of control loop.
(a) 1
(b) 2
(c) 3
(d) 4

Answer: (b)
Justification: Refer to slide 4 of lecture 5 from week 7

You might also like