Scribd
Upload
12 views2 pages

Document

Uploaded by

ronaldjamesmedina3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
12 views2 pages

Document

Uploaded by

ronaldjamesmedina3
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Make an steps/procedure in COC2 (SETUP COMPUTER NETWORK)

-SETUP NETWORK CABLE IN ACCORDANCE TO DIAGRAM (NETWORK TOPOLOGY)

STEP 1: Connect the Network Cable into Patch Panel according to Diagram and also the
color coding of wires.

Step 2: Start to connect the network cables between patch panel to router, patch panel to
access point, patch panel to client and Patch Panel to server.

Step 3: Then the cable of router is connected already at the number 8, and you must to
connect the cable at the back of patch panel with same number and then connect to Hub
switch. Same procedure of Access Point, Client and Server

Once u done, reset the Router by long pressing the button and start to configuring the
router

-Configure Router

Step 1: Go to Ethernet and Enable this network device

Step 2: Then go in “search bar” and type “cmd” type again “ipconfig” and copy the “Default
Gateway” (double click+control C)

Step 3: Go to "Chrome" and paste the “Default Gateway” (double click and control B) and
log in the TP LINK username/password "Admin"

Step 4: Click “Wireless” and change the wireless network name “Medina_rtr” and Password
“css@12345” kapag nag brows ang accessor ng wifi dapat ay maka connect sa
“Medina_rtr”

Step 5: “Change the Default Gateway to any IP Address Class” click "Network" and click
“LAN”

IP ADDRESS: 5.24.25.38

SUBNET MASK: 255.0.0.0

DEFAULT GATEWAY: 5.24.25.30

and click save.

Step 6: Back to Ethernet and Enable again Para talaga pumasok Ang IP Address na ipinalit
nyo at balik sa browser at i refresh

Step 7: Go to Command prompt and type ipconfig to see your new IP address
-Configure Access Point

Step 1: Go to Ethernet and Enable this Network Device

Step 2: Go to command prompt and type cmd

Step 3: Go to Chrome and log in the TP LINK username/password "Admin"

Step 4: In the Wireless Settings make your own Wireless Network Name "Medina_ap" and
then password "css@12345"

Step 5: Go to Network Setting set to "Static IP" and then the IP address also, and click
finish, wait until finish the restarting

Step 6: Then go back again in TP LINK and login

Step 7: Click Network and change the Default Gateway

You might also like