E030 The total counters are not functioning.

Related counter

E031 The optional counters are not functioning.

E032 The counters for ASSIST are not functioning. (Disconnection of counter pulse for ASSIST.)

E040 The lifter position signal fails to be generated due to a lifter clutch failure. Related paper
pickup unit
E041 The paper deck lifter fails to be detected within a specific time.

The roll paper cutting operation is not functioning properly because the cut motor does not work,
E042 etc.
An abnormal signal is detected due to a fault in the pick-up motor for the 3- cassette deck/3.5K
E043 paper deck.
A malfunction of the holding tray. A fault in the side registration is included. Related duplex unit The duplexing unit for the stack
E050 system

The home position of the side registration cannot be detected within a specific time. The duplexing unit for the
E051 through-path system

E054 The home position of the duplexing unit feed roller cannot be detected.

E055 The horizontal registration guide of the duplex unit exceeds its maximum travel distance.

E060 The home position of the primary corona wire cleaner cannot be detected within a specific time. Relateted charging

E061 Specific potential is not be required or the limiter is activated as the potential is controlled.

The photosensitive drum temperature does not reach a specific value due to a fault in the
E062 photosensitive drum heater, etc.
The home position of the transfer corona wire cleaner cannot be detected. An error code is not to be
E063 indicated.
The setting value for the output from the microcomputer considerably deviates from the control
E064 value of the actual output.

E065 High voltage leakage from the primary corona assembly is detected.

E066 Signals from the temperature/humidity sensor cannot be detected.

Two or more faults in the primary/ pre (post)-transfer/ transfer/ separation high voltage are detected
E067 (including power output stoppage, electric leakage from the primary corona assembly).

E068 High voltage leakage from or an open circuit in the separation corona assembly is detected.

E069 High voltage leakage from or an open circuit in the transfer corona assembly is detected.

E070 The home position of the transfer drum cannot be detected within a specific time. Related transfer

E071 An image leading edge signal cannot be detected within a specific time.

E072 A fault in the main motors such as the transfer drum motor, etc.

The transfer drawer connector or the transfer frame drawer connector is not connected as the front
E073 door is closed.

E074 The transfer belt unit does not reach the target position within a specific time.

E075 The transfer belt is off to the side.

E076 The transfer belt web is wound up completely.

E077 The motor inside the transfer belt unit has a fault.

E079 The home position (to apply pressure) of the transfer drum cleaner unit cannot be detected.

E080 An error occurs in the communication with the multi color unit controller PCB. Related developing
unit for multi color
The vertical motor clock is faulty. unit
E081
E082 The horizontal motor clock is faulty.

E083 The CD unit horizontal movement right sensor is faulty.

E084 The CD unit horizontal movement left sensor is faulty.

E085 The CD unit feeder release sensor is faulty.

E086 The CD unit claw release is faulty.

E089 A malfunction of the multi color unit.

E090 The document feed motor is not functioning properly. Related document
feeder (bulitinto
A failure in the detection of the document feed sensor. machine)
E091