E code Description Category Remarks

The fixing temperature does not go up after turning ON the power due to a fault in the thermistor or Related fixing unit
E000 the heater, etc.,

The fixing temperature abnormally goes up due to a fault in the thermistor or SSR, etc.
E001
The fixing temperature does not reach a specific temperature due to a fault in the thermistor or the
heater, etc. e.g) The fixing temperature does not go up to 190 C degrees within 5 min after
E002 reaching 70 C degrees.

The fixing temperature drops abnormally after wait time is up due to a fault in the thermistor, the
heater, etc. e.g.) After wait time is up, the fixing temperature drops to 70 C degrees.
E003

E004 A short circuit in the fixing heater drive circuit (SSR, etc) is detected.

E005 The fixing web is wound up completely.

E006 The fixing drawer connector is not connected as the front door is closed.

E007 The fixing film is off to the side.

A specific number of copies are made after the machine detects that fixing oil is out. Since a user cannot re-supply
fixing oil, the error code is
E008 indicated.

E009 The rated voltage of the power supply and that of the fixing unit do not match.

Clock pulses fail to be generated or the PLL lock fails to be released due to a fault in the main Related drum
E010 motor, etc. drive unit and
main drive unit
Excess current flows to the motor control circuit because the main motor is locked up, etc.
E011
Clock pulses fail to be generated or the PLL lock is released due to a fault in the drum motor, etc. In case the drum drive motor
exists in addition to the main
motor, this code refers to an
error of a motor which drives
mainly other units than the
E012 drum.

•The PLL lock is released because waste toner motor is locked up, etc.
•The micro switch employed to detect clogging of waste toner is activated.
E013 •The waste toner case is detected full.

•The PLL lock of the fixing/feeding motor is released.

•Clock pulses of the pick-up/duplexing/developing motor fails to be generated or be detected.

Excess current of the reciprocating motor of the photosensitive drum cleaner unit is detected.
E016
E017 The PLL lock of the drive motor of the holding tray unit is released.

E018 The PLL lock of the drive motor of the oil removing roller is released.

E019 The waste toner case is detected full although it is not.

The developer fails to be replenished with starter developer properly. Related A hopper motor error is
developing unit identified by the detail code of
E020. However, it may be
identified by E02x according to
E020 need.

The rotor fails to rotate and move properly due to a fault in the developing rotor/motor ass'y.
E021
Pressure fails to be applied to the developer after a specific time passes after the developer is
E022 selected.

E023 The developer sleeve motor fails to rotate properly.

E024 The developer cannot be detected. (The developer is not mounted properly.)

E025 Excess current of the toner delivery motor or the cartridge motor is detected.