0% found this document useful (0 votes)
49 views5 pages

2023-Nov-Dec-Network Analysis & Synthesis (AICTE)

papers

Uploaded by

vishalsahu5305
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
49 views5 pages

2023-Nov-Dec-Network Analysis & Synthesis (AICTE)

papers

Uploaded by

vishalsahu5305
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Printed Pages - 8 Roll No. :.

LIBRARY
B025413(025) RAIPUR. (C.

B. Tech. (Fourth Semester) Examination,


Nov.-Dec. 2023

(New Scheme)

(Electrical & Electronics Engg. Branch)

NETWORK ANALYSIS & SYNTHESIS

Time Allowed : Three hours

Maximum Marks : 100

Minimum Marks : 35

Note : Atempt all questions. Part(a) is compulsory


from each question. Attempt any two part
from (b), (c) and (d) of each question.

Unit-I

1. (a) Stateinitial and final value theorem. 4

(b) In the network shown in the figure 1(b), the switch


PTO
B025413(025)
|2 | | 3|
K is moved from position-position b at I= 0, a (d) In the network of the figure, the switch Kis closcd
steady state having previously been established at at t =0with the capacitor uncharged. Find values
for i, dildt and d ild at +, for clement value as
a position a solve for the current i(), using the
Laplace transformation method. follows : and C= 1 uF.

R
v
it)
V

(c) In the network shown in the figure l (c),


steady
state is reached withthe switch K open. At t =0, Unit-II
the witch is closed. For the element
value given,
2. (a) Enlist the necessary conditions for driving point
determine the value of y,(0-) and v, (0+). 8
4
functions.
100
(b) In the network of the fig, the switch is opened at t
10 s 20 2
= 0, a stcady state having previously been
established. With switch open, draw the transtorm
K
network for analysis on the loop basis,representing
5V
allclements and all initialconditions.
10n

B025413(025) B025413(025) PTO


|5 |

R R2
-10
Vo 104
R

(c) In the given network, the switch is in position a until


a steady state is reached. At t= 0, the switch is
moved to position b. Under that condition, determine
the transforn of the voltage across the O-5 F capacitor Unit-III

using
3. (a) Show the relationship between y and z parameters. 4
() Thevenin's theorem and
(i) Norton's theorem 8 (b) Find the y and z parameters for the resistive network
containing a controlled source as shown in the
accompanying figure.
12 22
-Ti0V
19
e)
2H V2

(d) For the given network in figure 2 (b), show that the (c) The network shown in the figure consists of a resIstive
equivalent Thevenin's network is represented by and. 8 "7" and a resistive "-network connected in
PTO
B025413(025) B025413(025)
|6| |7]
parallel. For the clement value given,determine the network (Ist form) and also as a Foster
V parameters. 8
network (2nd form). parallel

1 (c) The pole-zero plot of z (s) is shown below at


complex frequency is unity; z (-3) = 1.
32A
Foster I and II form of Synthesize
2n

-2

(d) Discuss the propperties of Positive Real


Function
(d) The network N in the figure is terminated at port 2 (PRF).
with a netwrok having impedance Z, = 1/Y,. Show
that 8 Unit-V

5. (a) Define active filters and passive


filters. 4

(b) Define the following parameters of a filter :


N V2 (i) Characteristics Impedance
(ü) Pass band
(m) Stop band
Unit-IV (iv) Cut-off frequeny
(c) Show that the resonant frequency is the geometric
4. (a) Enlist the properties ofRL impedance function. 4
mean of lower cut-off frequency and higher cut-oft
(b) Synthesize the network function as a Foster series frequency or
B025413(025) B025413(025) PTO
310]
(a)
characteristics
frequency Des1gn

a
prototype
of
2000
13(025)
impcdance
Hz. high [8|
pass
is
500 filter
ohm T
and
and
section
cut
ol1
il
8 8

You might also like