Lab Questions IOT AEC UPdated One
Uploaded by
AshishLab Questions IOT AEC UPdated One
Uploaded by
AshishDEPARTMENT OF ELECTRONICS AND COMMUNICATIONS ENGINEERING
IOT for Smart Infrastructure (21ECA765) -AY: 2024-25
LAB QUESTIONS Date:29-12-24
SEM:7th sem
1.Develop the program and interface the Ultrasonic sensors to control water level and use
LEDs as Indicators of different water levels.
2.Develop the program and interface the DHT11 sensor and moisture sensor to read moisture
level in the soil. Use LED as motor to get on when moisture level goes down below the
reference level.
3.Develop the program and interface the Servo motor, IR and ultrasonic sensors to monitor
and control waste in dustbin.
4.Develop the program and interface the ultrasonic sensor turbidity sensor, led, buzzer, to
monitor the quality and create alerts.
5.Wireless control of home appliances.Use Bluetooth HC-05 with Arduino board / ESP32
Bluetooth and LEDs as electrical loads
6.Develop the program and interface the IR sensors and Servo motor to find the parking slot
free.
7.Implement traffic light system. Use Three LEDs and delay of 5sec for red led, 2 sec for
yellow led and 3 sec for green led.
8.Interface MPU 6050 sensor with Arduino uno to find collision detection vehicle.
9.Develop the program and interface the IR sensors/ultrasonic sensor to control servomotor to
give access in toll gate system
10.Develop program to read DC voltage and display it on serial port/lcd display. When dc
voltage <3V, turn on load like LED.
Dr Vishwanatha V Dr. Parameshachari B. D
Associate Professor, Dept., of ECE, NMIT Professor and Head, Dept., of ECE,
Ms Smitha Sharath Shankar NMIT
Assistant Professor, Dept., of ECE, NMIT
Faculty-In Charge
