UM3000 UniversalMicroelectronic
UM3000 UniversalMicroelectronic
NOTES:
1. Measure from high line to low line.
INPUT SPECIFICATIONS 2. Measure from full load to 1/4 load.
3. Measure with 1 uF ceramic cap. connected to the output
Input Voltage Range …………..… 24V Nominal, 18-36 VDC
pins.
48V Nominal, 36-75 VDC
4. Non-latching shutdown protection.
Input Filter …………………………………….…… Pi Network
5. This converter require a minimum 10% loading on the
output to maintain specified regulation operation under
OUTPUT SPECIFICATIONS
minimum load conditions will not damage these devices.
Voltage Accuracy …………………………..…. ±1% max. However they may not meet all listed specification.
External Trim Adj. Range ……….……………..………. ±10% REMOTE ON/OFF CONTROL
1
Line Regulation …………………..………………±0.5% max. Logic Compatibility ………… CMOS or Open Collector TTL
2 Converter ON …………………..… >+2.5Vdc or open circuit
Load Regulation ……………………………..….. ±0.5% max.
3
Ripple and Noise , 20MHz-BW ….……. ≤25 mV RMS max. Converter OFF…………………… <+0.8Vdc or jump to pin2
100 mV P-P max. Control common ……………………………………….… pin2
Temperature Coefficient ……….….……. ±0.02%/°C max. Temperature derating curve
Overvoltage Protection Trip Point ( Zener Clamping Type ) Output Power
2.5V ………………………………………..….… 4.3V typ.
3.3V ………………………………………..….… 4.3V typ. 20W
5V …………………………………………..…….6.8V typ. 15W
12V ..………………………………………...…….15V typ.
Short Circuit Protection ………………………..… Continuous Ambient
4
Over Temperature Shutdown Point ……………..120°C typ. -40 0 65 75 100 Temperature
5
Minimum Load ……………………………….. 10% Full Load (°C)
Maximum case temperature must not be exceeded 100°C.
CASE B
PIN CONNECTIONS
PIN PIN FUNCTION
NUMBER Single
1 +Input
2 -Input
3 +Output
4 Trim
5 -Output
6 Control