Data sheet 3RR2441-1AA40

Current monitoring relay for IO-Link, can be mounted to Contactor

3RT2, Size S00 Apparant/active current monitoring 1.6-16 A, 20-400
Hz, 3-phase Supply voltage 24 V DC 1 change-over contact
Monitoring for Current overshoot and undershoot Current asymmetry
Phase failure, Cable break Phase sequence, Residual current
Blocking current, Switching cycle and Operating hours counter
Warning and alarm thresholds Auto-reset or manual reset ON delay
0-9999.9 s OFF delay 0-9999.9 s Reclosing delay 0-300 min Screw
connection system

product brand name SIRIUS

Product designation Monitoring relays
Design of the product digitally adjustable, 3-phase current monitoring, IO-Link
Product type designation 3RR2

General technical data

Size of contactor can be combined company-specific S00
Operating apparent output rated value 2.5 V·A
●
— insulation voltage for overvoltage category 690 V
III according to IEC 60664 with degree of
pollution 3 rated value
Surge voltage resistance rated value 6 kV
● protection class IP on the front IP20
● Protection class IP of the terminal IP20
Shock resistance 15g / 11 ms
Vibration resistance 10 ... 55 Hz / 0.35 mm
Mechanical service life (switching cycles)
● typical 10 000 000
Electrical endurance (switching cycles)

3RR2441-1AA40 Subject to change without notice

Page 1/8 09/25/2020 © Copyright Siemens
 ● at AC-15 at 230 V typical 100 000
Reference code acc. to DIN EN 81346-2 K
relative repeat accuracy 2%

Supply voltage
Type of voltage of the supply voltage DC
● supply voltage 1 at DC rated value 24 V
Relative negative tolerance of the supply voltage 25 %
Relative positive tolerance of the supply voltage 25 %

Measuring circuit
Type of current for monitoring AC
adjustable pick-up value current
●1 1.6 ... 16 A
●2 1.6 ... 16 A
adjustable response delay time
● when starting 0 ... 999.9 s
● with lower or upper limit violation 0 ... 999.9 s
adjustable switching hysteresis for measured current 0.1 ... 3 A
value
Accuracy of digital display +/-1 digit

Precision
Temperature drift per °C 0.1 %/°C

Communication/ Protocol
Protocol is supported
● IO-Link protocol Yes
IO-Link transfer rate COM2 (38,4 kBaud)
Point-to-point cycle time between master and IO-Link 10 ms
device minimum
Type of voltage supply via input/output link master Yes
Amount of data
● of the address area of the inputs with cyclical 4 byte
transfer total
● of the address area of the outputs with cyclical 2 byte
transfer total

Auxiliary circuit
Number of CO contacts
● for auxiliary contacts 1
● operating current of auxiliary contacts at AC-15 3A
at 24 V
● Operating current of auxiliary contacts at AC-15 3A
at 230 V
● operating current of auxiliary contacts at DC-13 1A
at 24 V

3RR2441-1AA40 Subject to change without notice

Page 2/8 09/25/2020 © Copyright Siemens
 ● operating current of auxiliary contacts at DC-13 0.2 A
at 125 V
● operating current of auxiliary contacts at DC-13 0.1 A
at 250 V
Contact rating of auxiliary contacts according to UL B300 / R300

Main circuit
Operating power
● rated value 2.5 W

Outputs
Ampacity of the semiconductor output in SIO mode 200 mA
Operating current at 17 V minimum 5 mA

Electromagnetic compatibility
EMC emitted interference
● acc. to IEC 60947-1 ambience A (industrial sector)
EMI immunity
● acc. to IEC 60947-1 ambience A (industrial sector)

Safety related data

Protection against electrical shock finger-safe

Connections/ Terminals
Product function
● removable terminal for main circuit No
● removable terminal for auxiliary and control Yes
circuit
● Type of electrical connection for main current screw-type terminals
circuit
● Type of electrical connection for auxiliary and screw-type terminals
control current circuit
Type of connectable conductor cross-sections
● for main contacts
— solid 1x (0.5 ... 4 mm²)
— finely stranded with core end processing 1x (0.5 ... 2.5 mm²)
● at AWG conductors for main contacts 1x (20 ... 12)
Connectable conductor cross-section for main
contacts
● single or multi-stranded 0.75 ... 4 mm²
● finely stranded with core end processing 0.5 ... 2.5 mm²
Type of connectable conductor cross-sections
● for auxiliary contacts
— solid 1x (0.5 ... 4 mm²), 2x (0.5 ... 2.5 mm²)
— finely stranded with core end processing 1x (0.5 ... 2.5 mm²), 2x (0.5 ... 1.5 mm²)
● at AWG conductors for auxiliary contacts 2x (20 ... 14)

3RR2441-1AA40 Subject to change without notice

Page 3/8 09/25/2020 © Copyright Siemens
 AWG number as coded connectable conductor cross
section
● for main contacts 20 ... 12
Tightening torque
● with screw-type terminals 0.8 ... 1.2 N·m

Installation/ mounting/ dimensions

● mounting position any
Mounting type direct mounting
Height 79 mm
Width 45 mm
Depth 80 mm
Required spacing
● with side-by-side mounting
— forwards 0 mm
— Backwards 0 mm
— upwards 0 mm
— downwards 0 mm
— at the side 0 mm
● for grounded parts
— forwards 0 mm
— Backwards 0 mm
— upwards 0 mm
— at the side 6 mm
— downwards 0 mm
● for live parts
— forwards 0 mm
— Backwards 0 mm
— upwards 0 mm
— downwards 0 mm
— at the side 6 mm

Ambient conditions
Installation altitude at height above sea level
● maximum 2 000 m
Ambient temperature
● during operation -25 ... +60 °C
● during storage -40 ... +80 °C

Certificates/ approvals

3RR2441-1AA40 Subject to change without notice

Page 4/8 09/25/2020 © Copyright Siemens
 General Product Approval EMC
Manufacturer De-
claration

Declaration of Conformity Test Certificates Marine / Shipping

Miscellaneous Type Test Certific- Special Test Certi-
ates/Test Report ficate

Marine / Shipping other

Confirmation

Further information
Information- and Downloadcenter (Catalogs, Brochures,…)
https://www.siemens.com/ic10
Industry Mall (Online ordering system)
https://mall.industry.siemens.com/mall/en/en/Catalog/product?mlfb=3RR2441-1AA40
Cax online generator
http://support.automation.siemens.com/WW/CAXorder/default.aspx?lang=en&mlfb=3RR2441-1AA40
Service&Support (Manuals, Certificates, Characteristics, FAQs,...)
https://support.industry.siemens.com/cs/ww/en/ps/3RR2441-1AA40
Image database (product images, 2D dimension drawings, 3D models, device circuit diagrams, EPLAN macros, ...)
http://www.automation.siemens.com/bilddb/cax_de.aspx?mlfb=3RR2441-1AA40&lang=en
Characteristic: Derating
https://support.industry.siemens.com/cs/ww/en/ps/3RR2441-1AA40/manual

3RR2441-1AA40 Subject to change without notice

Page 5/8 09/25/2020 © Copyright Siemens
 82.7

73

68

30
45

91
78.7

64.7

63.5

80.2

3RR2441-1AA40 Subject to change without notice

Page 6/8 09/25/2020 © Copyright Siemens
3RR2441-1AA40 Subject to change without notice
Page 7/8 09/25/2020 © Copyright Siemens
 C/Q
L+

31
L-
-K

IO-Link

32
34

A2
2/T1

4/T2

6/T3

14/22

last modified: 08/31/2020

3RR2441-1AA40 Subject to change without notice

Page 8/8 09/25/2020 © Copyright Siemens