30/10/2024, 11:50 Virtual Labs

R-L-C Circuit Analysis

60 90
Procedure: 30 120
0 150 61.9687
1. Closed the Switch(K). Set Input Voltage
Vin=220V. Closed 50
2 3
2. Set power supply voltage (VS) at=0V. Keep Vin 1 4 90
(in Volt) 60 90
all the resistance, Inductance, capacitance 0 5 30 120
220 60 90
at maximum position and switch on the 1.23937 30 120 0 150
circuit. Frequency 0 150
0.357 35.0359
3. Adjust the voltage across the circuit (VS) (in Hz) 95.2352
to about 70 V and note current(I), Vs, VL, 50 50
100
150 60 90 210
VC, VR and power(W) from the meters. 0 200 30 120
0 150
Click on "Fill The Table". 78.5399
4. Adjust the rheostat for several settings and 18.7895
repeat step 2.
5. Adjust the rheostat to the maximum setting Phase
Fill the Table 0
and change the capacitance to 0uF, 140 uF,
(in degree) -45 45
70uF and change the inductance to 0mH,
30 mH, 60mH repeat step 2. -90 90
6. Draw phasor diagrams showing VR, VL, Capacitive 11.9389 Inductive
VC, VS, & I for different sets of readings.

Observation Table
Serial no. Power Supply Vs Current I Power VR VL VC Theta
Power factor
of Observation (in Volt) (in Amp) (in Watt) (in Volt) (in Volt) (in Volt) (in degree)

1 220 3.471641198 602.6146307 173.5820599 98.13982505 52.63172479 11.93899002 0.978371610

2 180.399999 2.846745783 405.1980777 142.337289 80.47465654 43.15801432 11.93899002 0.978371610

3 161.48 2.548184640 324.6622479 127.4092320 72.03463159 38.63168599 11.93899002 0.978371610

4 135.3 2.135059337 227.9239187 106.7529668 60.35599240 32.36851074 11.93899002 0.978371610

5 78.5399999 1.239375908 76.80263207 61.96879540 35.03591754 18.78952575 11.93899002 0.978371610

https://asnm-iitkgp.vlabs.ac.in/exp/rlc-circuit-analysis/simulation.html 1/2
30/10/2024, 11:50 Virtual Labs

https://asnm-iitkgp.vlabs.ac.in/exp/rlc-circuit-analysis/simulation.html 2/2